Tom Watts

thomas.watts@windstream.com

Member Since: Dec 07, 2012

English
Tom Watts's Activity on Cisco Support Community
Currently displaying 50 results

Tom Watts has commented on Inter-VLAN routing, Auto-Voice VLAN and IP Address-Helper

2 weeks 5 days ago
If you're sending voice to only the Vigor modem then there is no need for a...

Tom Watts has commented on Sh int command SG500-28

3 weeks 5 days ago
There may be an expanded counter using SNMP. In most cases ETHERLIKE-MIB...

Tom Watts has commented on How to setup the trunk for private vlans across 2 switches (Both are SF300-24)

1 month 14 hours ago
I think he's just looking for PVE.  You can enabled 'protected...

Tom Watts has commented on SG200-50 aka SLM2048TNA not playing nice with VoIP system

1 month 14 hours ago
Hi Cumberland, I'd first start to say that I do not understand why you...

Tom Watts has commented on How to Connect Cisco SG-300-10 L3 mode Switch to SG-300-20 L2 Mode Switch

1 month 1 week ago
Hi Spati, There isn't a specific rule or guide line for your switch...

Tom Watts has commented on T1 Serial Overruns causing CRCs?

1 month 1 week ago
Hi Tater, CRC is kind of a catchall for Cisco. I have seen in some cases links...

Tom Watts has commented on How to Connect Cisco SG-300-10 L3 mode Switch to SG-300-20 L2 Mode Switch

1 month 1 week ago
Hi Spati, I think the confusion is the IP addressing you're using and...

Tom Watts has commented on Cisco SG-300 52 QoS default DSCP to queue mapping

1 month 1 week ago
I believe the answer to that direct query lies in RFC 2475 Here's the...

Tom Watts has commented on Poor network performance on SG500-52 ports

1 month 1 week ago
Hi Michael, I think there are 2 concerns to express. The first being since the...

Tom Watts has commented on Cisco SG-300 52 QoS default DSCP to queue mapping

1 month 1 week ago
The queue is a default standardized value. As such you'll notice queue 4 is...

Tom Watts has commented on Cisco SG 300-10 VLAN and IP Interface Question

1 month 1 week ago
Hi, when the port is access mode it is an untagged VLAN. From the looks of it,...

Tom Watts has commented on Unable to Access Management on Second Switch

1 month 1 week ago
Hi Terry, it sounds like your layer 2 switch does not have a default gateway...

Tom Watts has commented on SG300 Switch Security Concern

1 month 1 week ago
Hi Terry, you shouldn't have production traffic using the management VLAN....

Tom Watts has commented on show counters commands

1 month 2 weeks ago
If you're looking for ports being used you should be able to use command...

Tom Watts has commented on RV325 Router: Adding a wireless access point for wireless printer

1 month 2 weeks ago
Hi Jow, it sounds like you have this EA router connecting through the WAN port...

Tom Watts has commented on QoS questions SG200

1 month 2 weeks ago
Hi MaxHodges, the default QoS will apply to only tag VLAN packet from 802.1p....

Tom Watts has commented on Catalyst 3750 24FS-S Initial Setup help please

1 month 2 weeks ago
Hi Peter. Down not connect generally indicates the port does not see a link...

Tom Watts has commented on Enabling telnet on the RV320

1 month 2 weeks ago
Hi Marcin, this product does not have a telnet feature to manage the device....

Tom Watts has commented on DHCP SNOOPING IN CISCO SF200-48 SMALL BUSINESS SWITCH

1 month 2 weeks ago
Hi Bonnie, as far as I know DHCP snooping is not on the SX200 switch.I also am...

Tom Watts has commented on VLAN Port Tagging

1 month 3 weeks ago
The VLAN 10 won't touch VLAN 1 unless your router is routing it to touch...

Tom Watts has commented on VLAN Port Tagging

1 month 3 weeks ago
Hi Jay, VLAN's are kind of a funny thing. So, an "untagged VLAN...

Tom Watts has commented on Warning %STP-W-PORTSTATUS: gi1: STP status Forwarding

1 month 3 weeks ago
Hi Eddie, this log message is indicative of the link bouncing (periodically...

Tom Watts has commented on RV320 session time out

1 month 3 weeks ago
Hi Corey, I also do not see an option to increase the session expiration limits...

Tom Watts has commented on SG 300-28P changes to excluded

1 month 3 weeks ago
Hi Chris, depending on the phone model it may not support the CDP message from...

Tom Watts has commented on SGE2000 Web Interface not loading

1 month 3 weeks ago
Hi parking, if the GUI will not load please try the following; The same...

Tom Watts has commented on RACKMOUNT KIT FOR SG500X

3 months 4 weeks ago
Hi lschwam, the mounting brackets do not have an individual part number. You...

Tom Watts has commented on Only about 30MByte/s on SG500X between vm and Windows Client

3 months 4 weeks ago
Hi Spelzetter, if all of the links are participating in the link aggregation,...

Tom Watts has commented on Unregistered Multicast Filtering vs. NDP Protocol for IP V6 Ping SG300

3 months 4 weeks ago
Hi, IGMP and NDP don't work well together. You should be using MLD if any...

Tom Watts has commented on ESW520 24port switch question

3 months 4 weeks ago
Hi SWARD, on the ESW you need to configure the smart port role to switch.

Tom Watts has commented on Uplink two Cisco SF300 swicthes through SFP

3 months 4 weeks ago
Hi Tim, if you want to prove the wire and SFP is any good, take a transmit and...

Tom Watts has commented on How to search/Scan Vlan of cisco switch ports

3 months 4 weeks ago
Perhaps an OID such as vlanTrunkPortVlansEnabled 1.3.6.1.4.1.9.9.46.1.6.1....

Tom Watts has commented on SGE2000 - SG300 - MGBLH1 - Connectivity/DHCP/VLAN

3 months 4 weeks ago
Hi victvishwa, the SG2000 is a very old switch and sometimes does not work...

Tom Watts has commented on mistakenly installed RV042G v03 firmware on v01 RV042G

5 months 1 week ago
Should be able to fix it, this device during boot up looking for TFTP...

Tom Watts has commented on Understanding SG500 IP ACLS?

5 months 1 week ago
I am thinking you don't need an ACL at all. If you have 2 major aggregate...

Tom Watts has commented on SG300 DHCP Static Binds

5 months 1 week ago
Here may be a useful post. https://supportforums.cisco.com/discussion/...

Tom Watts has commented on sg300-28P dhcp server not using expired address

6 months 2 weeks ago
Hi ifrad, Try to configure a lease time and see if this fixes it for you....

Tom Watts has commented on RV180w PPTP Connection Problem

6 months 3 weeks ago
Hi Chris, if the netgear modem is performing NAT and is not supplying your...

Tom Watts has commented on SG300-52. Prefers to send traffic to default gateway rather than static route? Network halts if I disable ICMP redirects.

6 months 3 weeks ago
Hi, this is not running a routing protocol, therefore the most specific route...

Tom Watts has commented on Compatibility of MGBSX1 with GLC-SX-MMD

6 months 3 weeks ago
MGBSX is supported with GLC-SX-MM and SFP-GE-S, so yes, the link should come up...

Tom Watts has commented on RV042 PPTP Timeout Every 30 Minutes

6 months 3 weeks ago
Hi Cam, have you tried this with just the one computer or multiple computers?...

Tom Watts has commented on RV180w PPTP Connection Problem

6 months 3 weeks ago
Hi Chris, based off the info, the problem would be the new modem.I guess your...

Tom Watts has commented on Does Catalyst 3750G have IPv4-IPv6 translation feature ?

6 months 3 weeks ago
Your layer 3 network devices should be performing this function. If the 3750 is...

Tom Watts has commented on SMB Swutches for Regions

6 months 3 weeks ago
Hi, the switch region only matters for the power adapter. I do not believe CCW...

Tom Watts has commented on esw-540-48 - direclty connected to port 34, still no MAC in ARP table

6 months 3 weeks ago
Hi Firco, it may be possible it is a smart port issue. The ESW switches are...

Tom Watts has commented on STP traffic flow

6 months 3 weeks ago
I'd say it should work fine provided the EIGRP path cost is consistent to...

Tom Watts has commented on Trunks going to non-trunk and flapping

6 months 3 weeks ago
Host flap can be a difficult symptom to resolve. It may be a cause from several...

Tom Watts has commented on SG300-52 Remote Management Layer 3 Connectivity

6 months 3 weeks ago
Hi fearless, if you're looking for the configuration IP to manage the IP...

Tom Watts has commented on cisco sg200 voice vlan dhcp issue

6 months 3 weeks ago
Hi Ruchiran, this will depend on the IP phone. How it sounds to me, the phone...

Tom Watts has commented on cisco sg200 voice vlan dhcp issue

6 months 4 weeks ago
Hi Ruchiran, To cover the basis, ensure the VLAN 2 is added to VLAN...

Tom Watts has commented on Download/Backup Configuration

6 months 4 weeks ago
Try to log in to the console and paste a small section of the config at a time...

Bio










  • Cisco Designated VIP

    2015 Small Business





  • Cisco Designated VIP

    2014 Small Business





  • Cisco Designated VIP

    2013 Small Business









Tom Watts's Stats

Points4022
Discussion started 1
Answers marked as Correct 487
Endorsed 4
Content Rated 12