Vivek Ganapathi

Member Since: Jan 17, 2012

User Badges:
  • Silver, 250 points or more

English
Vivek Ganapathi commented on configure multiple ISE in Other Security Subjects 4 months ago

I would see this against a design guidelines. Also, the manageability of this setup would be a...

Vivek Ganapathi commented on ISE authentication with sw-to-phone-to-pc in AAA, Identity and NAC 4 months ago

Hi, Endpoint seems to be getting authorization profile. But it is not being issued a "Voice" domain...

Vivek Ganapathi commented on Cisco ISE - Windows Workstation not getting authorized until a port bounce is done in AAA, Identity and NAC 4 months ago

Hi, Few questions 1) Is the workstation performing dot1x? 2) What is the version of ISE? 3) Is it a...

Vivek Ganapathi commented on ISE authentication with sw-to-phone-to-pc in AAA, Identity and NAC 4 months ago

Hi, Based on the info provided, I believe ISE is unable to determine the IP Phone 1 as an "IP Phone...

Vivek Ganapathi commented on Unknown Unicast in ACI Fabric in Application Centric Infrastructure 4 months ago

Hello All, Firstly sorry for re-opening a very old thread. But thought relevant to discuss on this...

Vivek Ganapathi commented on printer profiling error. in AAA, Identity and NAC 1 year ago

Hi, Are you having any other modes of profiling enabled on the PSNs? For example : DHCP? If the...

Vivek Ganapathi commented on Cisco ISE: No 802.1x authentication for network devices looped via Atcom IP Phones in AAA, Identity and NAC 1 year ago

Hi, This is vendor specific. We had an issue with Avaya & confirmed a fix with Avaya support....

Vivek Ganapathi commented on Cisco ISE switch configuration in AAA, Identity and NAC 1 year ago

If all the clients are non-DHCP clients, then there is no configuration on core or distribution at...

Vivek Ganapathi commented on Cisco ISE switch configuration in AAA, Identity and NAC 1 year ago

Hi Marcus, It depends on your network design. If all the endpoints gets connected to access switch...

Vivek Ganapathi commented on vPC peer-link in LAN, Switching and Routing 1 year ago

In my view, auto-recovery feature is used to ensure that the secondary vPC peer starts to accept...

Vivek Ganapathi commented on vPC peer-link in LAN, Switching and Routing 1 year ago

Thanks Inayath. I can confirm your statement is 100% correct as i did the change few hours ago...

Vivek Ganapathi commented on vPC peer-link in LAN, Switching and Routing 1 year ago

Thanks a lot for your response Ganesh. Unfortunately, i do not have the auto-recovery feature...

Vivek Ganapathi commented on MTU issue in Switched network in LAN, Switching and Routing 1 year ago

Hi, IMHO, the client never talks to Cisco ISE directly. It is the NAD (i.e the switch) which sends...

Vivek Ganapathi commented on Downloadable ACL on Milti-Domain in AAA, Identity and NAC 1 year ago

Though this post has been answered. I would still like to add a few points - The only time an IP...

Vivek Ganapathi commented on Cisco ISE 1.3 - Unknown Endpoints in AAA, Identity and NAC 1 year ago

Did some analysis of a specific workstation not being profiled by ISE using the inbuilt Endpoint...

Vivek Ganapathi commented on Cisco ISE 1.3 - Unknown Endpoints in AAA, Identity and NAC 1 year ago

Any directions please? RegardsVivek

Vivek Ganapathi commented on ISE Admin Access Authentication to RADIUS Token Server in AAA, Identity and NAC 2 years ago

Hi Michael,Just wondering if you were successful to sort this out? I have a similar requirement to...

Vivek Ganapathi commented on OSPF path tuning based on destination prefix in WAN, Routing and Switching 3 years ago

Hi Roman,Apologies, i know this is quite late response. I totally overlooked the protocol. Yes,...

Vivek Ganapathi commented on OSPF path tuning based on destination prefix in WAN, Routing and Switching 4 years ago

One approach i see is to use a distribute-list to filter the route for 44.44.44.1 on the incoming...

Vivek Ganapathi commented on Priority queuing question in WAN, Routing and Switching 4 years ago

Yes, i think we can do something about your requirement here.  Solution would be configure Traffic...

Vivek Ganapathi commented on Priority queuing question in WAN, Routing and Switching 4 years ago

Hi Sandip,What is the router model on the internet edge?RegardsVivek

Vivek Ganapathi commented on Priority queuing question in WAN, Routing and Switching 4 years ago

Well in that case, i would suggest to speak to the ISP & get this clarified. In order for you...

Vivek Ganapathi commented on Priority queuing question in WAN, Routing and Switching 4 years ago

Hi Sandip,I would like to understand more on this, 1) Do you have an IPSEC tunnel running in from...

Vivek Ganapathi commented on Route map explaination in WAN, Routing and Switching 4 years ago

Hi Steven,Let me explain you this in my way. Route-maps is basically a function to customize...

Vivek Ganapathi commented on Static Route and BGP in WAN, Routing and Switching 4 years ago

Hello Joe,Default-originate is to originate a default route. But your requirement is to remove the...

Vivek Ganapathi commented on Static Route and BGP in WAN, Routing and Switching 4 years ago

Hi Joe,Just to add to Harold's point. I believe they might have been accessing internet through a...

Vivek Ganapathi commented on Datacenter routing in LAN, Switching and Routing 4 years ago

Hello Dan,There would be 2 options to sort this out. ...

Vivek Ganapathi commented on Migreting L2 to L3 with OSPF in LAN in LAN, Switching and Routing 4 years ago

Hi Venkatesh,Below are the things you may need to do 1) Move all your Layer 3 VLANs to 4500's2) You...

Vivek Ganapathi commented on IP SLA Failure in WAN, Routing and Switching 4 years ago

Hello Peter,Your configuration is perfect. I believe this is some freak issue. Suggestion would be...

Vivek Ganapathi commented on BW limiting for the Internet Proxy in WAN, Routing and Switching 4 years ago

Hello Dipesh,Are you filtering based on the source IP address while pulling the reports for that...

Vivek Ganapathi commented on Routing(Threat Pulse) in WAN, Routing and Switching 4 years ago

Hello Arun,You need to build an IPSEC tunnel to the Threat Pulse service provider. Below is a...

Vivek Ganapathi commented on NAT double translation in WAN, Routing and Switching 4 years ago

Hello Daryl,You need to advertise your NAT segments in EIGRP on R1 & R2. Create the below...

Vivek Ganapathi commented on NAT double translation in WAN, Routing and Switching 4 years ago

Hello Daryl,Please share the configuration. NAT statements, Routing Configuration etc. ThanksVivek

Vivek Ganapathi commented on Eigrp Behavior in WAN, Routing and Switching 4 years ago

Hello Pat,I would suggest to run debug eigrp packet & post the output here for further analysis...

Vivek Ganapathi commented on 2 ISPs Failover configuration in WAN, Routing and Switching 4 years ago

Hello Pavel,You need to have two default routes. One pointed to your primary internet Service....

Vivek Ganapathi commented on Redundancy scenario in WAN, Routing and Switching 4 years ago

Well, you can effectively use both the links ACTIVE-ACTIVE as this will effectively utilize both...

Vivek Ganapathi commented on Redundancy scenario in WAN, Routing and Switching 4 years ago

Hello Nihit,This totally depends on what has been agreed between your service providers. What is...

Vivek Ganapathi commented on BGP Conditional Advertisement ? in WAN, Routing and Switching 4 years ago

Got the answer ! To do a successful conditional advertisement, the route must be present in the...

Vivek Ganapathi commented on Securing router in LAN, Switching and Routing 4 years ago

Hello Vishal,Jimmy has provided you a perfect link to start. Certain things which needs to be...

Vivek Ganapathi commented on I am getting in LAN, Switching and Routing 4 years ago

Certain Printers have discovery feature which sends multicast. Network Scanning etc etc. Thats the...

Vivek Ganapathi commented on BW limiting for the Internet Proxy in WAN, Routing and Switching 4 years ago

Hello Dipesh,Looks to me like the BW report is overall. Your configuration looks ok. Being that...

Vivek Ganapathi commented on Convert from CatOS to IOS in LAN, Switching and Routing 4 years ago

Hello Jose,It is available on Cisco Site for download provided you have authorized CCO account....

Vivek Ganapathi commented on Convert from CatOS to IOS in LAN, Switching and Routing 4 years ago

Hi,As Reza suggested, that document would be a good start to understand how the conversion process...

Vivek Ganapathi commented on Applying QoS within IPSec and GRE tunnels.. in WAN, Routing and Switching 4 years ago

Hello Jit,Right. End-to-End QoS would be between your sites within the GRE tunnel. So, ISP wouldn't...

Vivek Ganapathi commented on Port-Channel Issue: SP-5-CANNOT_BUNDLE_LACP in LAN, Switching and Routing 4 years ago

Hello Mark,What is the IOS image you are running ?

Vivek Ganapathi commented on Applying QoS within IPSec and GRE tunnels.. in WAN, Routing and Switching 4 years ago

Hello Jit,Firstly, I'm not from Cisco Neither the information i have provided below is a view of...

Vivek Ganapathi commented on security Question in WAN, Routing and Switching 4 years ago

Hello Joseph,1) how to disable cdp on specific interface on a router Get onto the interface &...

Vivek Ganapathi commented on QOS scenarios in LAN, Switching and Routing 4 years ago

Hello,You are slightly confused. If your port is an access port or a layer 3 port, then you should...

Vivek Ganapathi commented on Cisco HSRP vs MPLS Fast Re-route in WAN, Routing and Switching 4 years ago

Agreed to vmiller. They are totally different technology / feature. HSRP is a First-hop redundancy...

Vivek Ganapathi commented on confused BGP path selection question in WAN, Routing and Switching 4 years ago

I will try to simulate this in my lab tonight. Will let you know the outcome. In the meantime, if...

Bio

User Badges:
  • Badge.
    Silver
    250 points or more

Vivek Ganapathi's Stats

Discussion started
Answers marked as Correct
Endorsed
Content Rated