William Benson

Member Since: Apr 05, 2011

English
William Benson's Activity on Cisco Support Community
Currently displaying 36 results

William Benson has commented on ASA 5505 NAT to and from multiple External IPs

2 months 3 weeks ago
It looks like for starts you need to add a third VLAN to your config.  You...

William Benson has created NATing issue (port forwarding) MPLS Outside address is a local address

2 months 4 weeks ago
I'm trying to figure out if what I've been asked to do is even possible...

William Benson has commented on Doubts about prioririty CoS and DSCP

3 months 3 days ago
Tagging the traffic you want with DSCP values is relatively simple.  You...

William Benson has commented on Doubts about prioririty CoS and DSCP

3 months 3 days ago
As long as you're routing across your own network then just setup your QoS...

William Benson has commented on Doubts about prioririty CoS and DSCP

3 months 3 days ago
Once the packet leaves your network (is routed) you no longer have the ability...

William Benson has commented on Multiple IP SLA tracked routes

3 months 3 days ago
That's the way I thought it should work.  I tried googling for...

William Benson has commented on Interview question: EIGRP and Grandmother

3 months 4 days ago
LOL JON!!!!!I don't think you'll get away with that one in an interview!

William Benson has commented on Interview question: EIGRP and Grandmother

3 months 4 days ago
I guess I'd have to relate it to something my grandmother would understand...

William Benson has created Multiple IP SLA tracked routes

3 months 4 days ago
I'm pretty sure this should work, but I hate assuming anything.  I...

William Benson has commented on ASA 5510 cannot ping via route inside

1 year 12 months ago
I upgraded the IOS on my ASA 5510 to 8.2 and BAM it all started working.  I...

William Benson has commented on ASA 5510 cannot ping via route inside

1 year 12 months ago
I found the write-up I've been looking for I think.It was titled "The Woes of...

William Benson has commented on ASA 5510 cannot ping via route inside

1 year 12 months ago
I tried enabling just the intra inteface for same-security-traffic and I also...

William Benson has created ASA 5510 cannot ping via route inside

1 year 12 months ago
Hey Folks,I would appreciate any feedback I can get on this.  I recently added...

William Benson has commented on Can one Root Bridge support multiple non-root bridges?

2 years 11 months ago
That was just too easy.I copied the configuration from the working non-root...

William Benson has commented on Can one Root Bridge support multiple non-root bridges?

2 years 11 months ago
That was just too easy.I copied the configuration from the working non-root...

William Benson has commented on Can one Root Bridge support multiple non-root bridges?

2 years 11 months ago
Thanks Steve,These bridges are mounted about 20 feet up in the air and since I...

William Benson has commented on Can one Root Bridge support multiple non-root bridges?

2 years 11 months ago
Thanks Steve,These bridges are mounted about 20 feet up in the air and since I...

William Benson has created Can one Root Bridge support multiple non-root bridges?

2 years 11 months ago
Hey gang,I have a pretty simple question here I think I have a wireless bridge...

William Benson has commented on 881W - NAT Without Using WAN port

2 years 11 months ago
Yes I've been doing this for a while, but I've never tried to use one of these...

William Benson has commented on 881W - NAT Without Using WAN port

2 years 11 months ago
Yes I've been doing this for a while, but I've never tried to use one of these...

William Benson has created 881W - NAT Without Using WAN port

2 years 11 months ago
Hey Gang,I'm trying to setup my 881W with multiple VLans to support guest...

William Benson has commented on NAT a local ip address to reach a remote ip address

3 years 7 months ago
I'm still stuck on this.  Is what I'm trying to do here just not possible? ...

William Benson has created NAT a local ip address to reach a remote ip address

3 years 7 months ago
Hey everyone,I'm trying to setup access to a remote host from my network using...

William Benson has created Routing between two different MPLS networks

3 years 7 months ago
I need to create a route between two different MPLS clouds hosted by different...

William Benson has created Cisco 2811 Router - Can you use CCP?

3 years 10 months ago
Hi All,I recently installed an 881W (perfect small office equipment WTG Cisco)...

William Benson has commented on ASA 5510 Site to Site VPN

3 years 10 months ago
MS,Thx for your help.  I'd like to mark a response as the correct answer, but...

William Benson has commented on ASA 5510 Site to Site VPN

3 years 10 months ago
IT'S WORKING!!! Underneath interfaces configuration menu there was a checkbox...

William Benson has commented on ASA 5510 Site to Site VPN

3 years 10 months ago
Also:From the 881W router on the other end, I can ping from a client computer...

William Benson has commented on ASA 5510 Site to Site VPN

3 years 10 months ago
I alredy lowered security-level to 0.  The error message your describing doesn'...

William Benson has commented on ASA 5510 Site to Site VPN

3 years 10 months ago
No dice...it's just not hitting the VPN ACL as traffic enters the switch on the...

William Benson has commented on ASA 5510 Site to Site VPN

3 years 10 months ago
This is the ACL that should be telling the ASA not to NAT and pass through the...

William Benson has commented on ASA 5510 Site to Site VPN

3 years 10 months ago
Here's the ACL hits if it helps:ciscoasa# show access-listaccess-list cached...

William Benson has commented on ASA 5510 Site to Site VPN

3 years 10 months ago
Since everything seems to look good, the tunnel is up and I can ping from the...

William Benson has commented on ASA 5510 Site to Site VPN

3 years 10 months ago
We're on a T1 to an MPLS, not a fast ethernet connection.  All of our larger...

William Benson has created ASA 5510 Site to Site VPN

3 years 10 months ago
Ok my forehead is sore from all the keyboard pounding I know this has got to be...

William Benson has commented on 5510 startup and configuration

3 years 11 months ago
Holy Cow...Thanks guys!! I was beating my head against the wall on this one.  I...

Bio












William Benson's Stats

Points25
Discussion started 9
Answers marked as Correct 2
Endorsed 1
Content Rated 6