worthingtontech

Member Since: Jul 17, 2012

English
worthingtontech commented on How to seperate traffic over 2 lines using 2811's in Remote Access 4 years ago

After working with Cisco, I was able to get the correct routing statements. It was PBR, with a...

worthingtontech commented on How to seperate traffic over 2 lines using 2811's in Remote Access 4 years ago

Hi Alain,   I was just wondering if you had a chance to look this over. I'm going to start...

worthingtontech commented on How to seperate traffic over 2 lines using 2811's in Remote Access 4 years ago

Thank you very much for taking an interest in this Alain. Here is the requested information. (I am...

worthingtontech commented on How to seperate traffic over 2 lines using 2811's in Remote Access 4 years ago

Here are the 2 site networks: 10.1.2.1 (Site 1) 10.1.3.6 (Site 2)Trace from Site 2 to Site 1...

worthingtontech commented on How to seperate traffic over 2 lines using 2811's in Remote Access 4 years ago

Currently, I don't believe we are. I ran the command above and there was no output. In looking at...

worthingtontech commented on How to seperate traffic over 2 lines using 2811's in Remote Access 4 years ago

Thank you for the reply Alain. Here is the information you requested:sh ip int br:Interface...

Bio












worthingtontech's Stats

Points0
Discussion started 1
Answers marked as Correct 0
Endorsed 0
Content Rated 6