zyang@cpg.org

Member Since: Feb 02, 2012

English
zyang@cpg.org's Activity on Cisco Support Community
Currently displaying 50 results

zyang@cpg.org has commented on VPC on Nexus 2Ks

9 months 5 hours ago
Thanks for the handy info!

zyang@cpg.org has created VPC on Nexus 2Ks

9 months 3 days ago
So my setup is a VPC with 5Ks and with each 2K with uplinks to only one 5K....

zyang@cpg.org has commented on Static NAT question for Routers

1 year 5 months ago
Yea at this point I think I have to add like 1028 static nat entries ... 4 x...

zyang@cpg.org has commented on Static NAT question for Routers

1 year 5 months ago
That only works after I started a communication from me to them.  If I dont,...

zyang@cpg.org has created Static NAT question for Routers

1 year 5 months ago
Been searching over but haven't found a solution.Basically, I want to do a...

zyang@cpg.org has commented on Stacked Cisco 3750

1 year 11 months ago
Yea I suspect that.  Thanks.

zyang@cpg.org has created Stacked Cisco 3750

1 year 11 months ago
I am trying to enable SSH, however the commands for Crypto are not available.Is...

zyang@cpg.org has commented on High CPU edge router

1 year 11 months ago
Also the interface for outbound traffic is:  5 minute input rate 627000 bits/...

zyang@cpg.org has created High CPU edge router

1 year 11 months ago
My edge router is pegged at 80% and interrupts at 8%.  None of the processes...

zyang@cpg.org has commented on Configuring Site-to-Site VPN on two ASA5505

2 years 6 days ago
If you are not seeing any debugs from the ASA, then there are no cryptographic...

zyang@cpg.org has commented on IKE Phase I Attributes

2 years 6 days ago
I got the answer for TAC.show crypto isakmp sa detailIt will give you the...

zyang@cpg.org has created IKE Phase I Attributes

2 years 1 week ago
Is there a way to find out which policy a peer has agreed upon?  I know it...

zyang@cpg.org has commented on Configuring Site-to-Site VPN on two ASA5505

2 years 1 week ago
If you ping the internal interface of the other ASA and you get nothing, check...

zyang@cpg.org has commented on Site-to-site VPN Failover with ISP Failover

2 years 1 week ago
If you can attach the same crypto map to multiple interfaces, can you create...

zyang@cpg.org has created Cisco ASA PFS

2 years 1 week ago
In the config for ikev2 you can specify multiple DH groups.  Does that work...

zyang@cpg.org has commented on Catalyst 2960 MLS?

2 years 1 month ago
They will be connecting to an upstream fw or router (depending on some other...

zyang@cpg.org has commented on Catalyst 2960 MLS?

2 years 1 month ago
Thanks, completely answered what I needed.

zyang@cpg.org has commented on Catalyst 2960 MLS?

2 years 1 month ago
Hi Peter,Does that mean I can create SVIs on the 2960s?  And just configure IP...

zyang@cpg.org has created Catalyst 2960 MLS?

2 years 1 month ago
Really dumb and easy question.Is the Catalyst 2960 series only layer 2 switches...

zyang@cpg.org has commented on ASA Object Searches

2 years 1 month ago
Is there no way to get rid of the extra input?Also I didn't realize you could...

zyang@cpg.org has commented on ASA Object Searches

2 years 1 month ago
That actually worked.  Thanks!Though it functions like a poor mans search...

zyang@cpg.org has commented on ASA Object Searches

2 years 1 month ago
For example say I have an object called serverA and it belongs to object-group...

zyang@cpg.org has created ASA Object Searches

2 years 1 month ago
Is it possible to search via command line what object-groups an object belong...

zyang@cpg.org has created Path Selection - EIGRP, OSPF, BGP

2 years 4 months ago
I have a DMVPN setup where our security wants us to disable split tunneling.  I...

zyang@cpg.org has created How do I pipe output in WLC 4400?

2 years 5 months ago
Like the way you do with the Cisco IOS.ie show start | i routerThanks.

zyang@cpg.org has created DMVPN and 2 Tunnels

3 years 1 month ago
Is it possible to disable split tunneling; where I want all traffic (even if it...

zyang@cpg.org has created Cisco 881 Software License Issue

3 years 3 months ago
Hi,I have been working with the 871 router and configuring it for work at home...

zyang@cpg.org has commented on Cisco WLAN Question

3 years 3 months ago
Hi sorry for the late reply. There was probably a misunderstanding. I wanted...

zyang@cpg.org has commented on Cisco WLAN Question

3 years 3 months ago
Hi sorry for the late reply. There was probably a misunderstanding. I wanted...

zyang@cpg.org has created Cisco WLAN Question

3 years 3 months ago
We have a Cisco 4400 series WLAN controller.When I go to the clients and view...

zyang@cpg.org has created Quiet Mode

3 years 3 months ago
Hi,I have a user who is a work at home.  She has an 871 Cisco Router with is...

zyang@cpg.org has commented on VLANs & Interfaces

3 years 4 months ago
Thanks for the answers!Been very helpful and illuminating.

zyang@cpg.org has commented on VLANs & Interfaces

3 years 4 months ago
Thanks for the answers!Been very helpful and illuminating.

zyang@cpg.org has commented on Ask the Expert: LAN Switching

3 years 4 months ago
Hi Matthew,CCNA newbie here.  Just wanted to ask a network design question..Say...

zyang@cpg.org has commented on Ask the Expert: LAN Switching

3 years 4 months ago
Hi Matthew,CCNA newbie here.  Just wanted to ask a network design question..Say...

zyang@cpg.org has commented on VLANs & Interfaces

3 years 4 months ago
Thank you.I checked it out and it seems they start at 1006+ vlan.I wasn't able...

zyang@cpg.org has commented on VLANs & Interfaces

3 years 4 months ago
Thank you.I checked it out and it seems they start at 1006+ vlan.I wasn't able...

zyang@cpg.org has created VLANs & Interfaces

3 years 4 months ago
A quick (possible dumb) question.If I have a layer 3 switch and let's say that...

zyang@cpg.org has commented on WLC & CAPWAPs Troubleshooting

3 years 5 months ago
ok thanks

zyang@cpg.org has commented on WLC & CAPWAPs Troubleshooting

3 years 5 months ago
ok thanks

zyang@cpg.org has commented on WLC & CAPWAPs Troubleshooting

3 years 5 months ago
At one point we had 160 clients, out of which 140 are associated and out of...

zyang@cpg.org has commented on WLC & CAPWAPs Troubleshooting

3 years 5 months ago
At one point we had 160 clients, out of which 140 are associated and out of...

zyang@cpg.org has created WLC & CAPWAPs Troubleshooting

3 years 5 months ago
We have 2 Cisco 4400 series WLC and a whole bunch of 1231G APs connected to it....

zyang@cpg.org has commented on CAPWAP Primary/Secondary/Tertiary Question

3 years 5 months ago
is there a way to show the primary/secondary on the AP as oppose to the WLC?

zyang@cpg.org has commented on CAPWAP Primary/Secondary/Tertiary Question

3 years 5 months ago
is there a way to show the primary/secondary on the AP as oppose to the WLC?

zyang@cpg.org has commented on CAPWAP Primary/Secondary/Tertiary Question

3 years 5 months ago
Ah, in that case that means I have to have the LWAPPs join the controller first...

zyang@cpg.org has commented on CAPWAP Primary/Secondary/Tertiary Question

3 years 5 months ago
Ah, in that case that means I have to have the LWAPPs join the controller first...

zyang@cpg.org has commented on CAPWAP Primary/Secondary/Tertiary Question

3 years 5 months ago
"ou need to run th config ap... from a WLC.  You have autonomous AP's so  you...

zyang@cpg.org has commented on CAPWAP Primary/Secondary/Tertiary Question

3 years 5 months ago
"ou need to run th config ap... from a WLC.  You have autonomous AP's so  you...

zyang@cpg.org has commented on CAPWAP Primary/Secondary/Tertiary Question

3 years 5 months ago
Show ap config generalshow ap config general                 ^% Invalid input...

Bio












zyang@cpg.org's Stats

Points10
Discussion started 22
Answers marked as Correct 1
Endorsed 0
Content Rated 11