This video explains the process of configuring Site to Site VPN between Cisco ASA and Cisco Router.
Nice Video, very informative and good step by step process. Well done!!
If you have trouble establishing VPN on one of the new 2nd generation ISR devices make sure that you enable PFS in your IPSec Policies (Crypto Map Sets) page in CCP or use CLI to do so.
Thanks for the extra note about PFS needing to be configured in CCP as this is what was catching me up. Without it, I needed to generate traffic from the ASA network side before the tunnel would come up!
I hope that they upgrade the video to include the newer ASDM interface and options and the appropriate configuration with CCP.
Prabhu, thanks for posting the walk through guide and video!
Thanks Prabhu . It was an excellent video and very nicely explained .
Looking forward to see more videos of configurations with CCP.
This is a very nice video. Short and simple to understand. Looking for some troubleshooting scenarios for the issues raised for TAC support.
This is realy nice and clean video for the novice users to understand the vpn ....
I can get the tunnel to come up but I cannot pass any traffic????
Check to see that your access lists are correct on both sides and permitting the proper subnets to talk.
shouldn't those be set by the wizard?