Grouping multiple ds0's from multiple T1 trunk

pbarman · ‎10-22-2003

AS5400-HPX and multiple TDM carriers entering my VoIP network via CT3. I know that using trunk grouping feature I can group trunks, ie, full T1's, and assign the trunk group to dial-peers and do whole lot of stuff.

What I am looking for is, if there is a way to group say 5- ds0 from say 10- T1's together into a group, and use that group into a dial-peer?

Thanks,

Partha

ketpatel · ‎10-27-2003

I dont think this is possible with PRI circuit but if you have CAS circuit I believe you can configure in following manner and have single ds0 picked out from a full T1. Please check the example attaced below. In the case below I have ds0 13 singled out from 2 T1's and both ds0 is assigned a single trunk group ID cisco#1

Hope that helps..

Regards,

ketan

!

controller T1 2/2

framing esf

linecode b8zs

ds0-group 0 timeslots 1-12 type e&m-fgb

ds0-group 1 timeslots 13 type e&m-fgb

ds0-group 2 timeslots 14-24 type e&m-fgd

cas-custom 0

trunk-group MCI

cas-custom 1

trunk-group cisco#1

cas-custom 2

trunk-group AT&T

!

controller T1 2/3

shutdown