Application Networking

After entering the subject command, should I expect to see flows still matching udp/53? I assumed the command would permit the passage of udp/53 and NAT the src/dst but not establish a flow. However, I am still seeing flows established. Any advice?Th...

Hello, we have a problem when we want to download a big file (for example a ISO image from redhat) The system cuts the download after of 20-22 minutes.Watching the log files of the "Content Engine" we can see the next message:in the next file /errorl...

Hi, there:Is that possible I could use IOS SLB and DNS failover automatically?i.e:vip 10.1.1.1vip 10.2.1.1dns records:vip1 10.1.1.1 10.2.1.1normal condition:vip1 will be 10.1.1.1when 10.1.1.1 failed it will give 10.2.1.1Is that something it could be ...

Does the CSS have the CSM feature to insert HTTP headers? I need to run my CSS in a one-armed configuration, but I still want to send the original client IP addresses to the servers. thanks in advance.

I'm at the design stage and have a choice of going either way for the solution. Has anyone got any critical reasons why 1 method should be chosen over the other - Bridged vs Routed?I haven't found any specific things that won't work in each scenario,...

Our Version:CSS 11050 SW Version: 5.00 Build 503Noticed that:Release Note for the Cisco 11000 Series Content Services Switch (Software Version 5.00.0.45) says:========================================The CSS does not set up flows if the source or des...

Hi,inserting the client's ip address into the http header using a CSM works fine. But after a a browser refresh, the information is lost.Is ther any way to overcome this?Thank youDarko

Good Afternoon,While experiencing some strange CSS behavior, I've been introduced to some of the more complex troubleshooting techniques in debug mode. I have a basic question about two show commands.The flow active listing is different than the flow...

When I configure a keepalive type as the ap-kal-ssl script, the keepalive fails. I found that the servers being monitored are prompting with a certificate warning (see attachment) informing me that the name on the cert does not match the name of the...

How to resolve service down event together with informing client this has happened possibly with TCP reset sending from CSS to client?We have ordinary configuration with two real servers and two content rules for http (L5) and https (L4). When servic...

Hi, I am connecting 2web servers, but http 80 port is working, 8282 port is not. On client, can open.. http://193.193.10.50/ekp/index.jsp but Can not open ..http://193.193.x.x:8282/RDServer/index.jsp .193.193.10.254 is default gateway on web servers...

Looking for a Cisco content switching tutorial or primer somewhere. I'll be taking a course next month and just want to start getting my feet wet. Thanks.

I am source natting the data traffic to the back end servers using a source group but I notice the health checks are not affected and they use the interface physical address. The way I found out is the service is down and the firewall was dropping th...