There are two ssl modules running on the two individual cat6500 switches. Two weeks ago, we updated the image of ssl module as 3.1(4).From the release note, we know that because the SSLM receives time setting from the supervisor engine, Network Time Protocol (NTP)
and module time setting are removed as configuration options. Time setting changes are configured
on the supervisor engine. You can configure the time zone information on the SSLM using the clock
timezone and clock summer-time commands.
So far the time of sslm is ahead one hour. But the cat6500 itself is correct. We already set up cat6500 as NTP server. Could SSL moudle send ntp request for sync time? please advice, thanks a lot!
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...