08-15-2007 01:40 AM - edited 03-14-2019 01:11 AM
Hi all,
I have 1 Cisco 3825 Router with module NM-1CE1T1-PRI
And i have one line E1 connect to this
I have configed Cisco AS5300 work with E1 line and callmanager, but with 3825 i have some problem
Any one can send me config example with 3825 router to accept incoming call and forward to callmanager
Thanks alot, vote 5* for your help
09-17-2007 02:11 AM
My E1 interface is on slot 1, port 0
After config controller e1 1/0, i config network-clock-select but see:
GW(config)#network-clock-select 1 e1 1/0
% Incomplete command.
GW(config)#network-clock-participate slot 1
Slot is empty or does not support clock participate
And when config voice card i see the
GW(config)#voice-card 1
^
% Invalid input detected at '^' marker.
GW(config)#voice-card 0
GW(config-voicecard)#
My E1 interface on slot 1, i cannot config voice card 1
09-26-2007 02:13 AM
Try this command "Sh Diag" & paste the output here.
Regards
09-26-2007 07:36 PM
Thanks all,
My problem is module NM-1CE1T1-PRI don't support voice.
If you wan to support voice you need module like:
NM-HDV2-1T1/E1(IP Communications High-Density Digital Voice NM with 1 T1/E1)
NM-HDV2-1T1/E1=(IP Communications High-Density Digital Voice NM with 1 T1/E1)
NM-HDV2-2T1/E1(IP Communications High-Density Digital Voice NM with 2 T1/E1)
NM-HDV2-2T1/E1=(IP Communications High-Density Digital Voice NM with 2 T1/E1)
....
or
VWIC2-1MFT-T1/E1
...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide