Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi I have a doubt about BE6K, Is this solutions support Third part SIP Endpoints, like grandstream or polycom? And if is true, What license support thjis pohone?Best regards
Dear all,I am facing Call Drop issue where both Incoming & outgoing calls are getting drop below is the debug error ,Please let me know how to get resolve this.
We're running CUCM Ver 7.1.5, the time stamp on all the phones is 4 minutes fast. How do you resolve this issue?Phones installed include: 7962, 7942, 7911, 7912, 7937, 7940, 7941.
We have CM 5.0 When we configure the phone button templete and bury it to 7961, it doesn't work. When the configured numbers are busy, the BLF signal doesn't light up. Is there any trick?
Hi,We have just sold a customer a Business Edition 6000 solution using version 9.x products.The customer wants:CUCM with LDAP integrationUnity Connection with Unified MessagingIM & Presence with Jabber for Windows and Jabber for iPhone clientsSo far ...
Hi, Currently work on multiple LANs designed for data. 6509 cores linked together using L2 POs. All HSRP/ OSPF Adj are via these links.Ive recenly read ideally VoIP needs L3 connectivity between cores, and distribution layer. L3 dist is a non starter...
Hello,We have a situation where FXO ports are connected to DMS-10 at telco end. DMS-10 doesn't send out any disconnect tone or power denial. Is there a way to detect on CISCO ISR that remote party has disconnected call? Is there a way to disconnec...
Hello,I did a Unified CM Cluster Overview report in CUCM 8.6 (a cluster with 2 nodes, replication is good) but it took a long time. So I stopped the process.But when I enter the Unified CM Cluster Overview in Unified Reporting, it shows that generate...
Hi,Could someone help me figure out the difference between using "Destination URI" vs the "Incoming URI" command to match a dialpeer?Which would take precedence if there are two dialpeers, one with destination uri and other with Incoming URI but the...
Hi allI knew that since voice register dn is single line, is not allowed to make a full consult transfer call on Call manager express (9.0), but is there any work around to permit it?in fact is a heavy constrain if it wouldn't be possible at all.Any ...
Hi All,I have created two extensions in Cisco 7861 phone.When I dial two extensions the same phone rings, however the phone display doesn't show two different lines. I have checked all display ID settings in the CUCM. It looks fine. When I do the sam...
Hi,I have a syetm that I have been asked to maintain. The system is Unity connection 7.1. I have the admin accounts to access the system but i do not have the OS admin passwords that are used to access the CLI or the OS admin/Disaster recovery.Is the...
Just upgraded a router to a 2911 with FXO ports. I have one Telco line for SRST and 911. When dialing inbound, I hear two rings, silence, then rings, and the IP phone will ring and get answered (Plar is set to the extension of the Cisco phone). ...
Does UM integration to Office 365 require that the hosted Exchange be AD integrated to the customer onsite AD with ADFS?Or can the AD/Directory in the cloud be standalone from the internal AD?Thx
All,I have a UC540 at a site that if it loses power and goes down hard when it comes back up it has reverted to an older configuration. I don't see anywhere to list a backup of the config, I save the run to start and that's it. It seems not to happ...
