Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi, Can anyone confirm me if it is possible to configure cisco B-ACD (normal AA features for forwarding call to desired extension with out manual intervention) feature in a normal voice gateway or it works only with CME feature??
Hi,I've configured 5 Tandberg MXP 3000 with version F9.1.2 PAL device on SIP directly on the CUCM 8.6 and all is working fine.I get an other Tandberg device Profile 42 C40 and I'm trying to register it directly on SIP as well but it's not working.I'...
Hi All,I have a situation where , six analog lines connected to the cme. PSTN lines acts as one main line and rest of the five lines are as parallel lines to the main line. Now the issue is , i can get the ring vlotage in the main line, output below;...
Hi, Has anyone any ideas on how to resolve this issue. We have a small helpdesk of 6 people that receive calls. Half of these calls need to be transferred off to an external company. So during the call the agent currently is forced...
Hi,I have cme 9.0 with ATA 187 We are facing the problem with this is that its getting hand after some hrs.Please reply.Thanks in advances
Hi,How to migrate from 6.1(5) to 8.6(2a) by building a new cluster in UCS? New cluster uses a new set of IP addresses and the migration needs to do site by site with intercluster trunk between the old and new.I found the following way and I stuck at ...
i have a remote site with a 2821 router configured as a h.323 gateway with a local pri. Calls come in and the extension rings, but, it takes about 5 seconds after picking up the handset for the call to actually initiate. So someone calls in and emp...
Hi,We are using Cisco CME and Unity Express 7.0. Is it possible to add passcode protection(or something similiar) to our meetme conference calls?
Hi All,I need urgent help, we have multisite deployment with centralized call processing system. Lets say we have 2 sites Site A and Site B.Site A = 8994999Site B = 44102111TeHO is already configured. When i dial mobile in site B area then i will dia...
It's a strange issue for ATA187 did not support data modem but we can not find the reason from any document......We know, ATA 186 and VG204 support the data modem. But anybody know why ?
Hi. I have a PBX connected to the Cisco 3825 router via one PRI line (I have one VWIC2-1MFT-T1/E1and one PVDM2-64 there) and there is a need to add another PRI link from the same PBX because one line is already not enough. This router acts as a VOIP ...
Hello Experts,We are expecting a integration for our Cisco CM and NEC SV8500 System integration this weekend. Does anyone done this before, appreciate if provide with a document on this.CheersBobby
I've been racking my brains but cannot think of a solution based on my knowledge. My goal is the following, A call comes in a) depending on if the business is open (time of day) the call is hunted first to a phone, if busy or no an...
IP Phone DN # 8330, 8222, 8072 at Cluster A---------> Called 8558--------> hits a Route pattern 8558 and transformed into 88888 and goes to inter cluster trunk non gatekeeper controlled trunk-------> Cluster B --------> but it Fails afterwards.....IP...
Hi, everybody!Just want to clarify some unclear points. I've set up a cluster of two CUCMs 7.1 in my lab. During the installation process I had to provide hostnames for both servers, so I chose cucmpub an cucmsub. I decided to refrain from using DNS ...
