Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
hello,We have a SIP trunk going from our CUCM to a SIP provider, the faxes are being sent right but we cannot receive faxes.Capturing traffic I see that the provider sends some INVITE messages correctly, but in the last one always the CUCM answers wi...
Is there a way to switch the type of phone that registers when using Simclient. Currently a 7960 phone registers and uses 4 unit licenses, we only have 500 units and we are unable load testing as much as we would hope.
Hi,Does anyone know if Simclient 6.2.3 is compatible with CCM 6.1??I dont see any CM Loads related to this.We have a heap of problems with this at the mo and tonnes of reg reject messages.If this doesnt work is there any other way to load test CCM 6....
my company want deploy a call center with multi-customer（hosted）now i config ICM and CVP but if only one hosted ICM run ，the CVP is OKif multi-customer run on the ICM ，the peripheral of CVP is configured---activing---active---configured----activing--...
Hi Guys,Pretty new to the CISCO world (post Avaya), but I have something that has me stumped and was wondering the best place to either see what is happening in real time or any logs to view historically to see what is happening...All of a sudden, th...
Hey folks. I had a weird one this week. I had three new wireless phones get the same error. Registration rejected.During troubleshooting, I stopped and restarted the TFTP service to no avail.Finally, I took a guess and turned off auto registration...
Here is a very quick question.If a CCIE has a job title in america as a senior network engineer, of a Network architect. What would the title be in Germany?
Hi There,We have configured Analog Ports in VG224 , It showing registered in CUCM, But there is no dial tone in FXS Ports, may i know what could be a problem?Faxmode is: Fax RelayRegards,Bala
What am I doing wrong?? This installation is baffling me.
Hello all,CME 7.1 have multiple extension and the main line "10" shared among all these phones, now when the call rings it rings on all the phones which is what i want, but when it get picked up the shared line it not shown in use.. What i need to be...
Is there any realistic ETA on when something newer like ICS will be release on the Cius? I wonder how many of the bugs would be remedied with a newer, more stable, OS. As well, I wonder how many fixes on the current OS will occur again after the mo...
I have a UC560 with PRI for voice and data at primary site. There are 2 remote sites which connect to the primary site with mpls and the data network is routable between all three sites.Can I deploy IP phones at the remote sites and register to the U...
I hava Cisco Unified CM Administration System version: 7.1.3.30000-1I was analyzing the traffic of my subscribers servers and found a issue.The keepalive messages from my ATA186 to CM is marked with DSCP 26 but from CM to ATA is marked with DSCO 24....
I have uploaded a new wallpaper and can manually select it in my background images. I was wondering if it's possible to remotely deploy this so I don't have to go around to each phone.
I have one voice gateway 2901 and cue is working. whats the config to create voice mail for fones registered on cme.
