Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello everyone, I have a proble with a callmanager with a trunk sip against IVR of prosodie. I'm going to try explain the problem.The call come in to CallManager and this send the call to IVR through Trunk SIP, until here everything are ok , then the...
I currently have a hunt group that has been configured through the cisco CLI. I want to add some extensions, but am not having much luck. Is there anyone that can help me out with the commands?Here is the current configurationvoice hunt-group 2 paral...
My apologies if this is a double post, I think my original went to the wrong forum.I'm using CME 8.x on a 3800 ISR, and a couple of 6921 phones. Two of them have ~8.5.3 code, the others have 9.x code (phone loads). If I'm understanding things cor...
Hi All,I have a H323 gateway (Avaya) added into a CCM 4.1.3 , when Cisco Phones receive calls from the Avaya gateway, the phones only show unknown number (external) but the Avaya phones can see the Calling Party Name. Any idea what I should set on th...
Hello All - We have Cisco IP Phones 7965 and would like to configure one of the button to do an intercom call to one specific person. The user would click on this assigned-intercom button and auto-dial the assistant. The person initiating the inte...
Hi All,I am trying to configure a basic poor mans call queuing system using call handlers on Unity Connect (ver 7).I am trying to copy something similar to the below suggestion I found, which should put a caller on hold automatically.Call_Handler_A: ...
I know that in 6.x you can rebuild a Publisher, restore the databse via DRS and the Subscribers will sync back up..However the DR Guide for 7.1 seems to suggest that Subscriber nodes also need to be restored from DRS after a Publisher has been rebuil...
Vaguely remember setting this in Unity enterprise. I want to allow Unity to just attempt to forward calls to Communications Manager even if it doesn't have a matching Subscriber account DN.Thanks in advance,Brian
Hi Rafael, We also have similar setup, where I have a FAX connected on VG202 over SCCP with CUCM 7. And CUCM routes the call to Sip CUBE Gateway. Which is not working. Could you pls guide us how to solve this problem. RegardsSKR
HiWe are trying to get Siemens Gigaset 685IP phones to register with CME 8.1, but are having trouble to get it register as SIP devices. Does anyone know if there are any interoperability issues between the Gigaset 685IP phone and the CUCME, the phone...
Any idea how you can determine the number of phones on a particular firmware on call manager 7.15?
Hi,I am using CUCM 7.1.3 and I have few questions. Can someone please help me?1) Is it possible to find out when the phone (device/line) is actually configured in CUCM?2) Can we pull the information when the phone is registered for the first time and...
Dear All,I have CUCM ver 6 and I want the callers from outside my company only to listen a greeting message when they call some specific phone numbers inside my company in which:1. The caller calls (for example 2121555)2. The caller listen the greeti...
Hi I can see in the doc that you can change the FROM address in RTMT alarms. I just can find out where it is.Regards,Thomas
HiIn CUCM, we have configured the Hardware and Software Conference Bridges. We have the Meet-Me conference. Can we increase the number of participants more than 8? If we increase the number of participants, how is the resources used from Hardware and...
