Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I have to deploy several hundred phones quickly to a site that will have a small link back to our TFTP running on our pub. I am trying to upgrade the phones to the current version of firmware we are running on out cluster. I have configured a switc...
Hi All,We are running CUCM 6.X in a cluster environment. There's one publisher and few subscribers in this cluster and phones on the respective locations register with the respective subscribers which are sitting on those locations.I configured devic...
In CUCM 7.0.1 called party mask is not working for me, I have applied partition in called party transformation mask and css in gateway level, but the called pary transformation is not working at all for me, any suggestion for called party transforma...
How to install an HP tape trive in cisco callmanager....HP Tape DAT 72...
HelloHow could i track a call on CUCM 4.2 for a Sip trunk configured???...what is the step by step???I have a sip trunking between a CUCM 4.2 and third-party vendor, i desired to watch whether the sip trunk is up and also if the call is passing throu...
The system allows us to use **50 to access "speed dials" that all users in the company can use. I cannot find info anywhere that tells me how to do this
HiI have a problem in North America. There is a provider that can map names to mobile numbers, so a name is displayed for all mobile calls. That's a nice service that I haven't been in contact with in Europe. Now there is a problem with the name that...
I would like to know if it is possible for the following two scenarios to happen... Let’s say I FWD my calls to 613-111-2222 (home) from my work number 613-786-1111. Our general number is 613-233-5555. What I see at the present moment is this. If som...
I have a UNity 5.X Unified messaging, If I call internal to a phone with a mailbox the message never arrives.if I call externally or from an internal phone with no mailbox all is okay,Any ideas??
Good Afternoon -We recently installed new services at a site and decided to go with POTS lines for backup connectivity in the event of the failure of our T1. We are sharing these pots lines between a fax machine(s) (direct, not through the voice gat...
I have downloaded this file cmterm-7940-7960-sccp.8-1-2.cop.sgnI wander how I can use it...it didn't open by ZIP/RAR...Please notice that only this file cmterm-7940-7960-sccp.8-1-2.cop.sgn have text:Cisco IP Phone 7940 and 7960 firmware release 8.12...
I am restoring my current 6.1 call manager to a spare server in my lab so i can test the upgrade of 7.1.is there a way to change the mac address on a DL320 so my license file will allow the call manager service to start.i want to test our devices and...
Does anyone have detaisl on adding new did's into call manager
Hi thereI have setup the UC520 for most call processing tasks and one of the things that are pending is voicemail. When I dial 500, the number just beeps 4 times a second.TPOC-UC520#sh run | be dial-peer voice 2000dial-peer voice 2000 voip descripti...
Hi all, replaced an aging 2651xm mgcp gateway, with a newer 3825 12.4(22)yb4 code, loaded with extra dsp's which have registered and are being used for transcoding, hardware mtp, and conferencing. The gateway has also registered, and will happily e...
