Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi all,When i receive a call from the pstn to a cisco ip phone is there any way to associate a name to the number where i reveive the call (calling number).Thanks
Hello,in our installation we use a CTI Server from the company servonic with the application IXI-Call 3.After some troubleshooting, why we have multiple lines for each user (extension mobility users), we and servonic found out that the Callmanager se...
Hello folksI just reset a phone and is stuck in configuring ip, under enterprise parameters we have the ip address of the publisher to remove the DNS dependency, the phone is configured in ccm what else should I check?thanks
how to configure Mute Features for IP Phones on CCM 6.1 Regards
Hi,we are looking for recording on unity connection wherein when a user receives a call on IP phonefrom PSTN.The conversation which happens between PSTN user & IP phone user gets recorded .Is that possible in Unity Conenction 2.X?regds,aman
How I can to reset o recovery web password of the Cisco unity express GUI interface??? I can access to CLI interface only.Thanks
Someone can help me? I trying to do this with CLI,tnx a lot
UCM 6.1.3.3190-1My AC user can go online fine with Call Control up. If i configure broadcast hunting however the AC answers the call automatically as it should, places it in the Broadcast queue however it does not appear in the Broadcast calls window...
Hi, I have this VIC card installed on both a 2801 and 2811, I have tried connecting the two back to back using different cables but have no luck, I have used a normal straight through and a cross over and I have also used a cable with pins 3 and 4 to...
Hi ,Is there any way to find the serial number of Cisco MCS server(IBM/HP ) on which cisco call manager version 4.X is installed.regds,aman
I have to handle roughly 400 numbers to go out different ports. I have only dealt with single T1's in the past and don't know where to start with the dial-peers in an implementation this big. How does one create dial-peers for such a large group of...
Is it possible to reinitialize the DC Directory on 4.1(3)? I had a BARS restore that failed, because I ran of disk space and now I cannot logon to BARS. I was hoping that I could logon again and try the restore.
Hello,After analizing VoIP call traces, I noticed that:When a SIP call is placed the caller uses source port 5060 and destination port 5060. The called peer addresses response messages to port 5060 with source port 5060. Now, when a H323 call is plac...
I have a lobby phone that is attached to an FXS port and want to use COR to limit the user to internal, 911 and local calling. Basically block LD. How do I attach the COR list to the FXS port? The examples attach it to an ephone-dn.
Hi All,I have been asked to test the Cisco Unified IP Phone 7960G (11 nos). Need to verify that the phones are in working condition. Can you please provide me the details to perform the same.Thank you,
