Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Dear ExpertsI have ccm 4.2 and tring to configure IPMA with proxy line, I run wizard of IPMA and intall assistant console on a pc.I give parameters i.e IP address of subscriber and port 2912 and try to connect but error occur " unable to connect to s...
The 7911 phones were connected to ccm before. Now I am trying to connect to cme4.2 on router 2811.I still noticed that the old configuration is avialable in phone settings.I reset the factory defaults since then phone is not able to load its firmware...
hi,Does anybody know if single number reach works with Huntgroups in CCM version 6.1.2Cheers,Derek
Hi,I have a problem with sip incoming calls: the incoming call arrive to a 7931 IP phone, If i set a Forward no answer to another phone the call fail.If I set an Hutgrout with the same phones the calls work well.I need to route the incoming call to a...
I currently have a 2821 gateway with dial-peers. Access code is 7 along with 10 digit dialing. The end user dials 77042895829. The CCM routes the call to the gateway. The router sends 10 digits, which includes the access code, but strips the last...
If you want to Integrate CME with an analog Voicemail system like Octel the only way to do this is with FXS ports, right?What if the Octel voicemail system is integrated to a PBX and you have a T1 between the PBX and the CME, will you be able to inte...
hello all...i have a lab setup question and i need a solution.my question is i have created a hunt ,with my pilot no: as 7777.I need to call to this no: from my pstn line.my gateways are also added.wot are the necessary config that i need to do.
Hi,I have the following setup, both routers are Cisco 2811, I am trying to simulate PSTN on one routerB running CME and routerA is an MGCP GW controller by CUCM5. When placing a call from RouterA to RouterB the call goes through fine but when a call ...
Hi,Were having issues dialing the UK from or California office. We can dial all of our international sites except the UK. Below is a debug for the dial peer and q931 on the PRI. The number were calling is British Telecom as an example. Dial Stri...
If I understand this correctly when I enable DirSync then my CUCM publisher will pull data from AD, store it locally, and query against it when a DIRECTORIES search is done on a Cisco phone?There is also a setting in CUCM under CUCM ADMINISTRATION-->...
The company I work for uses Cisco IP Phone 7941 Series. When I call potental clients the phone rings but the call time counter on the screen doesnt start until someone picks up or an answering machine answers. Is this counter the call time counter? I...
Hi experts,I have been dealing with an issue while trying to connect a Nortel BCM to a Cisco CCM, basically I was able to configure both of them but for some reason I am only able to have they working together with g.711alaw, if I try something diffe...
Hii need some help with installing a 7960gip phone in my call manager express 4.0 router.i have already configured everything on the router but the ip phone just displays "configuring ip"i have 7911 ip phones and they are working ok.
We are doing a CUCM 6.X integration with Microsoft AD using LDAP.Can you pls share any exact doc on this.~Shiv
Hi, i have four VG248 with 1.3(2) version in the same site. The problem is the VG248 are reseting. For this i checked in the System Status the Up Time param. The fault is random.The logs are not show the reason for the reset.Pls see the attachment.
