Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi friends,Is there any possibilities to make forward commands in CME, like FNOA, FBUSY to be applied only to calls coming from outside, and dont operate in internal calls?Thanks, Met.
Hello friends,Is it possible to configure, in CME, an extension to transfer the call NOAN after X seconds, but after the transfer, it rings on the destination extension and still rings in the original destination extension? (two phones ringing)?Thank...
I have a UC520 with Cisco IOS Software, UC500 Software (UC500-ADVIPSERVICESK9-M), Version 12.4(11)XW7, RELEASE SOFTWARE (fc2).I have installed a VIC2-2BRI-NT/TE interface Cards in UC520, now i have 4 ISDN Basic Rate interfaces.i want to use one of th...
I activated CFwdAll on my extension to forward all calls to my mobile. When I receive the call on my mobile I always see the main number of the line as caller ID if an external user is calling my extension. I know it is because the callmanager is sen...
Is it critical for CCM if I'm planing to change my windows domain?
Hi All,Could anybody let me know if running DMA for data collection on a production system is service effecting? Any recommendation from Cisco to run the data collection out of hours?Thanks a lot.
Hi, i have 3 sites and 3 CCM cluster version 4.2 with active directory integration. Now, i need to have 3 attendant console, one by site. The problem is only one ac user id (in the active directory) is permit for attendant console. Any way to do this...
HiHow can I do to telnet Unity Express (NM-CUE) remotely?I'm in site A and the NM-CUE is in Site B, I need upgrade language and I can't telnet to NM-CUE, just GUI. It's normal?Thanks
Hi.I need change the SP code in a dial-peer, example:02111........ to 01511........or02511........ to 01511........How can I do it in CME?Thanks
Hi,I have CUCM 6 and I'm configuring line group with Distribution Algorithm Longest Idle, i want know longest idle based on number of calls received by ip phone user or total time spent by ip phone user on the calls. BRHaitham
I see two versions that support mainline 12.4.cme-basic-124-1.tar and cme-gui-124-1.tar---or---cme-basic-3.3.0.3a.tar and cme-gui-3.3.0.3a.tarAre cme-basic-3.3.0.3a.tar and cme-gui-3.3.0.3a.tar specifically for IOS 12.4.3 but I would use cme-basic-12...
Guys, i wonder if anybody can help. I'm having a problem with the BRI ports on two gateways. one is showing BRI0:0 multiple frame established BRI0:1 tei assigned. 0: up up 0:1 up down. only thing i'm unsure about is encapsulation type is voice.2nd ga...
HiMy name is Jefferson Islan from BrazilWhat the last version of Call Manager?Thank you
after a call is made from IPphone to mobile(for eg), even after disconnecting the call from IPphone its not getting disconnected on mobile...inshort the fxo port is still active..the voice port remains off-hook..so gotta manually shut and open voice ...
Hi, I have a setup of CCM 5.1(3) and voice gateway. the voice gateway has NM-CUE module for voice mail. i have integrated the CCM 5.1(3) and UNITY EXPRESS using the integration document. cti route point and cti ports are gettting registered. But when...
