Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I'm setting up QoS on an existing network to support VoIP based on Cisco Call manager, phones and 2600 voice gateways. I'm unable to determine if the gateways automatically tag the RTP and call control packets with the appropriate DSCP values, or if ...
I have central call processing, 2 offices, each with their own GWs.I am having trouble with international calls from one of the offices (Office A). My international Route Pattern (INT_RP)in CM is simply a 9.@ for Office A. For Office B (INT_RPB)it ...
Hi,where can i find the firmware loads for 7942 and 7962 phones.I checked in Cisco but m not able to find it.
Hi all,I've configured the following translation pattern:1000 is translated to 000461234567890When I call 1000 I hear a continous tone for about six seconds before I get a ringback tone.Any ideas how I can shorten / remove this?I'm running cm 3.3Tha...
Dear all,I have a strange situation. I've got ccm4.2 and Cisco Unity Connection version: 1.1.1.0.somehow I have problems with cfwdall to voicemail and extrnal calls, it simply doesn't work.internally there are no problems.but if the phone is set that...
hi We have a CUCM 6.0 setup with 2811 router as the voice gateway.I have configured it for SRST also.I have made the necessary changes in the CUCM.I am able to view th SRST Ip address in the Ip Phone also. But when i try to create a ACl in the...
It's been a while since I've had to deal with any of this...Can CallManger 4.13, running in Win2K, be put in a Windows domain? If so, any gotchas I need to watch out for?Thanks.
Hi,I have set up a CCME and l am having some problems with 7910 phones trying to register to the CME. They can get an IP Address via the DHCP and everything else looks OK, apart from the Call Managers they are homed to. Is there a way to factory defa...
2 users were on calls. Both users had dead silence on their calls at the same time, and at least one of the phones said CM unavailable, features disabled. The call came back momentarily, then there was silence again. Hung up the receiver and the p...
Hello,I have been tasked with handling a PRI cutover (we are getting rid of legacy PBX and going with a callmanager solution (with 2811 router with Vic2-2mft T1. I have minimal experience with routers/switches.I understand how to configure the T1 for...
How to disable the Web access, please provide the steps for the same...Web access enable option cannot be changed to No on the security configuration.appriciating for quicker response...
Currently in the input settings for the auto attendant [*] will send the caller to the Sing-In conversation. When you hit [*] in the AA, the call is disconnected immediately, never prompting for a ID/password.It tried mapping it to [#] or even numeri...
I upload a wav file with the next format:16-bit PCM ,Stereo and sample rates of 48kHz in the section "Music On Hold Server Audio Sources", and select this file in the fields "User Hold MOH Audio Source" and "Network Hold MOH Audio Source" in the pho...
is this possible and if so, how?Does IP Communicator have add-on features such as side car [i.e. 7914 expansion modulars]?
Hi all,IN a CM4.2(3), How can I receive all incoming calls from a E1 (MGCP gateway) in a HUNT LISTthanks in advance
