Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
How do you register a PDA in CCM
Hiis there a way of doing a password recovery for CDR. I have tried the default (admin, admin) and the administrator account but I still can't log in.ThanksMichael
i have a call manager that connect to a gateway router and the router connect to e1 this e 1 has 100 numbers like from 55812.. to 5581299 i need when someone call 5581250 go to the fax which connect to fxs port exist on the router how can i do that
Hi,We are currently testing a UC520-solution. Internally we can call without problems, but when we try to call out, we get a message: unknown number... .I suppose it has something to do with the dialing plan, I am using the Cisco configuration assis...
I have a location where all of the phones now have only a couple ring tones. After the installation the phone had a number of ring tones. What can cause this and how are ring tones downloaded to the phones they have 7960's and 7961's
Hello - I have CCM 4.2(3) and a 3845 MGCP gateway. Between the gateway and my legacy IVR (Edify Workforce) I have a T1-CAS circuit. I can successfully place a call into my IVR. My IVR has a script that allows me to input an extension and be transferr...
Hey i have an ATA186 connected to a CME. From any phone you are able to call the analog phone interfacing the ATA, but the outgoing call from the ATA doesn't work. I don't hear dial tones.any ideas?
We have the following VoIP setup:Site1_PBX---VoIPgw--**network**--VoIPgwGk--Site2_PBX--**network**--VoIPgwGk--Site3_PBXcodec = G.711fax protocol = modem passthroughvoice and fax are working fine in both directions between Site1 and Site2. voice and f...
Hi i have a question related to the component: NM-2W so can we use VIC2-4FXO with that network module within cisco 3845?
HiI am running MGCP controlled gateway with fall back to h323. But, after disable serial cable from the link to CCM, I still cant see srst kick in. Is there bug in IOS Or any issues like that.I am using AdvancedIPServiceK9 release 12.4(3g) on 3845.Th...
Hi,We have got a 2800 router configured in CCM5.1.2 as an H.323 gateway. There are plenty DSP resources in it so we want to use it as a hardware transcoder. But as soon as we try to create a transcoder in CCM with the gateway's IP address the CCM say...
I have a 7835 MCS Server and I'm trying to install OS Version 2000.2.3 and I'm getting the error "Non-System Disk" blah blah blah when booting with the CD in. Any help would be moocho appreciated.
I'm done tuning another CME / B-ACD / CUE setup for a customer. They got like 60 extensions and quite busy, on a 2851. This was the 8th hunt-group we set for them. They never had any issues after startup.At some point I tough a reload was necessary b...
For T1 PRI interface, I show InStatus and OutStatus as NONE when I do a show voice port summary. The port is enabled. How do I get out of NONE status and back to IDLE so it can accept/make calls
Hello guys,Are there any functionalities or features that Avaya phone system offers that Cisco CallManager can not? I am replacing an Avaya phone system with Cisco Unified solution and would like to know what are the features and functionalities that...
