Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I deleted a phone from the device list intending to let it auto-register again. When I powered the phone up again it registered and works, but does not show up in the administration/devices gui. It does show up in the real-time monitor/devices.Idea...
On CallManager 5.0(4) I installed a new 7941G as a SCCP Phone. It worked but calls to it's extension failed "You call can not be completed as dialed. Please consult your directory..." Calls from the phone work.Ideas?Jim
problem: I have a CCM 5.0 on Virtual Machine, it starts up and prompts for the admin account after I entered the account every thing goes fine, finally I got admin:prompt with a black screen (for CCM linux OS commands) I set IP address then when I t...
This site is equiped with a 2 vg200 gateways for handling IN/OUT calls FXO connections 4ports each on vg200's.2 routers (1760 and 2621XM).Routers are responsible for the internal calls in the same organisation, which also can act on SRST mode. The p...
<deleted>
Currently, we are a Lotus Notes shop, and running vm only Unity 4.0(4).I will be installing new servers in a failover enviornment and upgrading to 4.2. Also, I have a third server which will act as the Exchange server.Our company is looking to move ...
I have configured event monitoring to page me when I recieve error messages on my Unity Server. The monitoring systems works great, however, when i recieve and error message, there isn't any documentation to tell me how to fix the errors. Can anyone ...
Hi all,I'm looking for some advice/information about set up some QoS (marking voice-packets) at the edge device (PC).Thanks.Greets,Norbert
one of my customer has one 3825 with NM-HDV2-1T1/E1 installed which only has 1T1 PORT.right now, they are going to order an extra T1. so what part they need to order to get an extra T1 port? I hope they dont need to order a NM-HDV2-2T1/E1 card. thank...
Does anyone happen to know how Cisco is handling the early March time change with the servers for CM and IPCC that are running under Windows 2000 as Microsoft is not putting out a patch so solve the daylight savings time issue? Any info would be very...
I have two lines with same DN as follows,line1=1000,P_internal, cfb=1000/css_2ndlineline2=1000,P_2ndlineIn the case 1st line busy, Can I display the caller name for the 2nd call. currently, ringing the 2nd line in the case 1st busy.Advise please,
Hi,Is it possible to exchange text messages between the IP phones?? and if so is it only possible within the cluster??.. Anybody can give some tips on the same pls..Regards
I have an extension that is linked to a unity subsriber only by MWI alert. I have over 2000 subscribers on the server. Is there a way to find out which subscriber this extension is configure to alert MWI on ?
Hello , I have a 2801 running c2801-advipservicesk9-mz.123-14.T5.bin - I have a few phones connected to it; doing remote breakout on simple ISDN lines.Is there a way (with this software) to see how many outgoing / incoming calls I have had per num...
HiIn CallManager 4.1.3 you can see the amount of MTP resources allocated under 'service parameters - Cisco IP Voice Media Streaming App - MTP - Call Count' as 48.However when I open performance monitor, CallManager, MTP and add 'resource available' a...
