Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Do I run the upgrade utility first before running bars? I am asking this because if the upgrade utility fails, the backup would be bad anyway and I would need to fix whatever is wrong first then do a backup.
Hello folks, I found the follow links for those installation:http://cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803f3a9f.html#wp1028403My question is: is its the only steps that I need to do or I will need t...
They have software S280IPV-12311T on their bill of materials. Do I need to have a show ? command run on the router to know what version it is? What command do I use for an older version?
I have a CME 3.3 with 7902, 7912 and 7940 IP phones and I want to do fast dialing for certain numbers.For example, I'd like that from any phone, the user dial the number 300 and it were converted to the 964812510 ( the number of my head office ) How ...
CallManager 4.2.3 - using 7941's /7961's. Departmental Pickup groups have been setup and utilized effectively for weeks/months. No changes then all pickup groups fail. User hits the softkey for 'Pickup' and it does nothing. Phone reset's have no e...
Whilst researching the ATA 188 for a CCME implementation I noticed it went end of sale last year ? Has anyone used the suggested linksys replacements with CCME. ?http://www.cisco.com/en/US/products/hw/gatecont/ps514/prod_eol_notice0900aecd804047cb.ht...
Hello All,I have a CME and CUE implementation. A user has asked than when a call comes into her DN that if after 5 rings it is not answered, a message is played something along the lines "we are trying to connect you, please wait" and then for the c...
Folks, I have callmanager running 4.2 and ipcc 4.x on the same box, can i install csa on it? does anyone know what version?
I have user created in ccm and appears in DC directory but when try to search him through cooperate directory, only his name appears but not extension.Any thoughts about it. I am using CCM 4.2(3)Cheers
I have dual-line mode configured in a IP phone 7940 so when you are speaking and a new call comes you can see in the screen the call and the number. Then I answer the second call holding the first and try to transfer the new call to another extension...
Hi Can anyone advise why the default device pool showing red status for the small PC icons.Does this mean the pool is not operational for use. IE if I add it to a ip communcator phone will it work in the red status.Any help would be appreciated.
I have a 3.3.4 CCM and going to have it replaced for a new server with 4.2.3 version.I want some ideas to get a backup of the configuration and CDR data from the old server, so I could pass it somehow to the new one.I heard the BARS works with same v...
I was installing a brand new 7911 and after a few boots the phone does start anymore.On boot, it flashes the leds, then all lights and display stay off. I've seen that it keep sending DHCP request despite getting replies from the router. Is there any...
I want to have more than one sip account configured in my cme, but in the sip-ua I only can introduce one account.How can I do it ?
i am trying to set up VOIP using 2 c2821 routers but when i do show run, i do not see the voice ports. card type:VIC2-4FXO. but when i do show version, i discover that the voice card is there. can anyone help me? KUFRe
