ā10-08-2013 10:22 AM - edited ā03-16-2019 07:46 PM
I have a cat 6500 with a Supervisor 2T
My data vlan is 94 and my voice vlan is 104
The phone and PC will be on different ports, but typically, I use this setup
interface GigabitEthernet1/2/1
switchport access vlan 94
switchport trunk allowed vlan 94,104
switchport mode trunk
switchport voice vlan 104
auto qos voip cisco-phone
spanning-tree portfast
However, when connecting a phone or PC to the network, I get no layer 3 (no ip address from DHCP, etc.). Phone says unregistered.
inline power is working
Should I be using a different port setup?
Solved! Go to Solution.
ā10-08-2013 10:41 AM
Hi
please try the below
interface GigabitEthernet1/2/1
switchport access vlan 94
switchport mode access
switchport voice vlan 104
auto qos voip cisco-phone
spanning-tree portfast
or
interface GigabitEthernet1/2/1
switchport trunk native vlan 94
switchport trunk encapsu dot1q
switchport trunk allowed vlan 94,104
switchport mode trunk
switchport voice vlan 104
auto qos voip cisco-phone
spanning-tree portfast
Thank you
please rate all useful information
ā10-08-2013 10:41 AM
Hi
please try the below
interface GigabitEthernet1/2/1
switchport access vlan 94
switchport mode access
switchport voice vlan 104
auto qos voip cisco-phone
spanning-tree portfast
or
interface GigabitEthernet1/2/1
switchport trunk native vlan 94
switchport trunk encapsu dot1q
switchport trunk allowed vlan 94,104
switchport mode trunk
switchport voice vlan 104
auto qos voip cisco-phone
spanning-tree portfast
Thank you
please rate all useful information
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide