02-07-2009 09:41 AM - edited 03-15-2019 04:03 PM
Hi,
I have a analog phone conected to a fxs port in the 2821 router(using sccp). If this analog phone call to a ip phone (local or remote), is transconding resources requiered ?.
Solved! Go to Solution.
02-07-2009 12:59 PM
Hi Rafael,
The FXS port is going to use DSPs no matter what, since it is an analog connection. Since these are the same DSPs that do transcoding, it's fairly equivalent to transcoding.
Depending on what codec CUCM negotiates with the gateway, the DSP will simply change what codec it is using.
This isn't something to worry about, unless your DSP resources weren't allocated correctly for high complexity codecs.
You can use the DSP calculator to be sure:
http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl')">http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl
hth,
nick
02-07-2009 10:49 AM
No it is not as the GW can negotiate any codec.
Chris
02-07-2009 10:58 AM
what codec have you configured each device to talk?????
if G711 there is no need
HTH
java
if this helps, please rate
02-07-2009 12:59 PM
Hi Rafael,
The FXS port is going to use DSPs no matter what, since it is an analog connection. Since these are the same DSPs that do transcoding, it's fairly equivalent to transcoding.
Depending on what codec CUCM negotiates with the gateway, the DSP will simply change what codec it is using.
This isn't something to worry about, unless your DSP resources weren't allocated correctly for high complexity codecs.
You can use the DSP calculator to be sure:
http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl')">http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl
hth,
nick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide