MPLS

Hi Experts,I am a newbie with Cisco Firewalls, pls help.We have a BSNL Leased Line of 2MBPS with few Static IP's of Which 2 IP's are configured in Firewall 1 For the Outside Interface and one for publishing the DMZ server. Most of the times due to so...

Dear all,I have configured VRF on 3750 whose other lies in other edge of my network. the VRF is spanned via GRE tunnels across the IP backbone. i have a vlan on 3750 switch whose SVI is configured with source select and vrf receive. The problem is a ...

Hi,A MPLS network with 6500 series switches on distribution and also on core layer,Acting as a PE.CE---DS_SW/PE-----Core_SW P/PE----ISP/PE Client are connected to distribution switch(PE)and traffic is label switch between distribution and core switch...

In the diagram i have 2 sites. In site 1 i have 2 PE devices with Vlan 3,33 in VTP database and couple of servers in both vlans. Need to extend both vlans broadcast domain to site 2 access layer switches. MPLS/LDP enable on PE's. I am assuming that w...

Extract from MPLS VPN Architecture chapter 9...."Contrary to the traditional BGP operation in which the internal BGP routes are not allowed to be redistributed into other routing protocols, this restriction is lifted in the MPLS/VPN environment. The ...

Dear friends,When I tried to simulate the ATM network for Ammavan Thomas regarding his question here about the MPLS over PPP over ATM I came across a strange problem.I was experimenting with two IOS versions for 7200 series on dynamips. I have used t...

hi.. :)I have a question about ES Card. Also I consider to purchase that module as soon.We have a plan using the es card to Router QoS.the point is that the ES Card support all of router qos? ex) MQC, Shaping, CBWFQ..thanks in advance.

What is the recommeded number ofce's in a full mesh.and can you have more than one ce onthe same PE with physical different interfacesin the same VPLS domain

Hello,I am doing CSC with IGP/LDP between carriers.R1 is the second level carrier.R9 is in the backbone carrier.R9 has a VRF interface towards R1 with MPLS enabled.The network is 123.1.9.0/24.Because this in a VRF, R9 creates a VPN label for 123.1.9....

HI,Just would like to know the supportability of PPP Network Control Protocol for MPLS(MPLSCP/TAG CP) in Cisco?When another vendor sends MPLSCP Conf-request in PPP , Cisco side is dropping this message with the following debug message displayed:> ...