Hello all,can someone give me advice on configuring "SNMP v2". I've a wan with 128k with about 16 spokes and 1 hub. I want to get statistic so I'm afraid if SNMP will kill my little bandwidth.best regards,Alcides Miguel
I have a 3845 ISR that I have been managing for a couple years that has a traditional ACL based config. We just purchased a new 3845 for redundancy and it arrived with the zone based config from Cisco. Any opinions on whether I should take the exis...
Hi,i tryed to configure ip sla and got message-c3825(config)#ip sla 1%Already at System Maximum Number of Entries of 17324But there are not any ip sla entries....How to fix it?Regards,Mike
i have LMS 3.2 installed in my campus. i need the serial number of the LMS suite to open a service request with cisco. but unable to find the same. can you advice me about how to find the same. thanking in advance
helloim trying to get netflow working on a me 6523 to a destination address using udp port 4739 but im not getting anything through wire shark while connectedto a span port on the router or the connecting switch.Im using the management interface whic...
HI,I have LMS 3.2.1 installed in my server. When I am try to create a new collector the expected source device is not appearing in list of devices source device list. However the device is added under IPM devices and reflecting under destination devi...
Hi,Best pratices indicate to configure local timezone and sumer time when configuring NTP.However, I don't understand the need to configure that on NTP clients as the NTP server already gives the right clock.Tahnks for your help.D.
Hello, I was wondering if anyone knew of a tool that can manage the IP Addresses of a small company. Maintaining the old familiar spreadsheet of who have what IP Address is becoming more troublesome that what it is worth. Basically what I am ...
Hello,we changed the LMS from a self signed certificate to a certificate issued from our corporate ca. Since about 30 services could start anymore. We are using LMS 4.1 on a Soft Appliance.I verified the certifcate with the SSLUtil and everything loo...
I am only able to get InfoAlarm messages sent to via email notifications.My switch is sending logs to Cisco Works.Example:13. 10.10.0.1 10.10.0.1 Apr 04 2008 10:34:41 EC 5 UNBUNDLE Interface GigabitEthernet1/4 left the port-channel Port-channel2 * 14...
Good day,I installed CWLMS on a Windows 2008 R2 virtual server.It was all working 100% but now after a reboot I suddenly can't start the deamon services.The web portal opens and i can login successfully but as soon as i run the discovery it says i mu...
Hi,is it possible to add devices to DCR automatically from the CLI? Pratically if I export all the devices using cwcli utility in CSV format, can I import those devices to the inventory with the same format (CSV) .I want to put this command in the au...
HI All,We are using LMS 3.1 and it was working fine . Suddenly ANI Server is failing to run as below. ANIServerFailed to run0-11073741823N/A9/29/2011 2:02:57 PMThought of re intialising ANI database , but still it is not working . pls assist to solv...
Hi, I don't know if this was asked before or not.I configured my Discovery settings in such a way when new devices were found it will automatically go to a specifice group, user defined group but it's not ahappening, it goes to somewhere else, either...
HelloWe are running LMS 3.01 and have been currently experiencing issues regarding the login page. It has been stuck on the page that states "Server Not Ready - System is coming up - You will be redirected to login page soon". It has been like this ...
