Network Management

Hi All, We have Cisco 1602 APs and 1702 Aps are installed on the same floor, with same WLC. client is trying to connect to 1700 and getting fluctuation. even the channel utilization is low RSSI is good and SNR is also good for 1600 APs. Any suggesti...

Please provide the steps or commands to check synchronisation of Primary & secondary ACS server

Hi friends, I have created one profile in Cisco prime for compliance check, under that I have created one policy. Under the policy I have created a rule and in that rule I have created 8 conditions. line vty 0 4 exec-timeout 30 0 loggi...

Hello Team, I am unable to reach proxy server when entered proxy IP in admin (system settings) to reach Cisco.com. Can I add static route pointing towards Proxy server in Prime CLI? If yes,same command of static route will work?

I have just upgraded our Cisco Prime 2.2.3 to 3.1.5 and need to configure access through ACS 5.8. Right now I have configurations done and it's attempting to login but I get the window on the screen that states: "No authorization information found fo...

Estimados Gradezco su tiempo y pido disculpas por adelantado por alguna infracción que cometa, paso a detallar la situación, tengo un router Cisco rv130 vpn, tiene una red vlan de defecto con la 192.168.8.x, otra vlan con la ip 192.168.9.x en donde ...

Hi Guys, Is there an way to get a SFP serial number in the device inventory through Wired Device it is saying its fixed in 3.0. But i am not able to get the details for the SFP modules. any help is appricated. Customer Feedback: Capture serial num...

We want to use Syslog via 514, but want to setup using a local. How can I find out a devices' local?

Hello. I have just discover that CNA 6.2 have some problem with full support for C2960X. In may case there are 8 switches WS-C2960X-24TS-L and on all of them CNA have problem with presenting Front Panel led status view. All information about port st...

Good morningI wanted to know with version 3.3.1 of the Cisco CLI Analyzer there are 50 token available for each month, so I wanted to know sel at the beginning of next month they return 50 tokens to use in the current month.Thank you

Below is the config in my branch router. logging source-interface GigabitEthernet0/0.6logging host 172.16.10.5 IP of Gi0/0.6 of branch router is 10.50.20.2 There is a FWSM firewall between branch router and the Syslog server at head office. Even if ...

Hi,       I have stacked two Catalyst 3850 switches. Server Machines with dual NICs were teamed and two NICs are connected to each switch. i have done the following configurations on switches. 1. created VLAN with interface and added ports of switch ...

After upgrade from PI 2.1 to PI 2.2.3 and everything working fine for a couple of hours. The Administration > System Settings section doesn't give any options to change anything. It shows the selections, but the information for each link just shows a...