Hi,
I am using IOS 12.4 on a 2811.
I have NAT setup as :-
Fa0/0 set as inside
Dialer0 set as outside
Now I also have some static NAT entries for some servers.
But when I try and access one of the staticly NAT'ed servers from inside, using the Public IP address, it fails.
I can ping the server from inside using the public IP address, but cant make any TCP connections.
I tried passing traffic through a loopback interface by seting a policy on Fa0/0 to send packets ment to the Public addresses via the loopback, but no traffic seems to go through.
Have also tries route_maps on the nat, but to no avail.
Is this even possible ??
i,e Open a TCP connection from 10.1.1.x to 212.x.x.103, where 212.x.x.103 is staticly NAT'ed and 10.1.1.x gets PAT'ed to 212.x.x.101 ??