10-10-2001 10:05 AM - edited 03-12-2019 12:51 PM
Anyone tried this?
I set the gatewayIP in the ata to my CCM.(the field GkOrProxy is 0, and UseLoginID=0!). now I can make a call with my ata, but can't recieve a call. I made a h323 device on the CCM, with the ip-address in the name. I added line 1 with the number that I put on UID0 on the ata. (do I have to add line 2, for the 2nd port?, or can I add another device with the same IP-address?)
thanx :-) Sascha
10-16-2001 09:33 AM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
11-18-2001 05:09 PM
Did you setup a route pattern on the CM to point that extension to the H323 gateway? Also try resetting the gateway from the CM. You don't need to setup the second line for the first to work. Also firmware version 2.12 is out on CCO.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide