Other Collaboration Subjects

Is it possible to configure a 3524 pwr xl for port security and have a seperate vlan for data and voice on each port. I do not want the data in the management vlan, as I saw in one example configuration. From what I have read, we are supposed to keep...

Are there any recommendations on DSP Planning at the remote sites for Centralized Call Processing? When is it recommended to inclulde DSP's at the remote location for transcoding and conferncing?

Can someone here elaborate on the new phone load that gets rid of the Polycom banner and supposedly improves the speakerphone quality? We have had a number of complaints from individuals using the 7960 speakerphone.I heard this was related to the rec...

We have a customer who is running ICD V2 and we are going to upgrade to V3 enhanced. Since it is a live system we plan to build the new ICD on another server with different name and IP address and run the two in parallel for a while with different ro...

I have CM 3.3 and Unity 2.4.6(161) and TSP 7.02. Is it necessary to turn off Cisco Messaging Interface or can I leave it running? I know there are problems in the past if this service is running, but is it still the case with CM 3.3

How to convert demo to full version on unity4.02?I recall in unity 3.x, I have to run the setup again, is same deal for unity 4.02 or just go to licensing to install the license? If that case, do I have to rerun the message store wizard or something ...

Hi,Can some one indicate ma a cisco document that I can find some recommend sound card for my Agent desktop Media Termination.Best Regards

Hi,I am writing an TCL application that requires to send the 'subsriber=" VSA attribute to the radius server in the authorization packet.The Radius VSA implementation guide says this attribute is only present when AVSEND is added to the TCL script. ...

I have compaq DL380 and I want to move it to Compaq 1805. My first question is that will Compaq 1805 is supported if yes than what is the procedure to move the call manger to another server

HI, I have an ATA 186 registered to a GK. And I have an AS5300 registered to my GK too(without tech-prefix).What should I set in the GK to route a call from the ATA to the GW....I would be very gratefull If somebody could help me..Regards,

Hi,I am having 3600 Router in INDIA , currently having 2 Serial & 1 Ethernet Card in it , now I want to Put an extra Card (NM-HDV-1E1-30 ) in my Router & wants to Integrate it with my PBX. So that users at my end can make & receive calls from US thro...

I have a callmanager cluster running 3.2(2c). I have installed the new Callmanager backup utility 3.5.18 and have backed up my database. I'm planning to upgrade into version 3.3 and import the backed-up file in 3.3Any known problems for that?Any hint...

Hello:In the url:http://www.cisco.com/warp/public/cc/pd/si/casi/ca3500xl/prodlit/cfig3_an.htmThe url say :The Catalyst 6000 and the Catalyst 4000 switches support a special multiservice port to connect to the Cisco IP phones. The Catalyst 3500 series...

We have a Publisher and a Subscriber an we installed Extension Mobility of both. If the Publisher going down, the Phones Service-Button (7940+7960) say "Host not found".How are config this for redundance ?Thanks !D. Eckhardt