Other Collaboration Subjects

My application log is filling up with the following 'INFORMATION' message. Anyone seen this before, regarding regarding the MOH service. If so, any solutions?Information:SDIControlLayer::SDIConytrolLayer[]-host name or op = 10.60.61.198,DBL [3.1[0....

I loaded 12.2(11)YT on a 2611 and copied the required files to flash for ITS. The telephony-service command is not available. Is there something that needs to be done for this command to become available? any help is appreciated

Hi, Ive seen a number of training videos for 4.X are there any available for 3.X System Admin. e.g runs through the SA pages

Is there a limitation to the amount of ccmadmin sessions that can be open at once?

I want to install 5 Unity servers, all to be installed at various remote locations in the corporate WAN. We have them all at the hub site, and I intend on installing as much as possible on them here before shipping them, and myself, out into the fie...

I am trying to set up a 4 port Auto Attendant on a Call Manager system I have running. The Call Manager version is 3.1(3c) and the Application Manager version is 1.2a. I have managed to get the application engine running, but the JTAPI subsystem ne...

We are installing 3.3 on an IBM x345 which meets the Cisco approved hardware list. We have the CCM software for the x345 supplied by Cisco. Hardware detection is failing with the generic "This CD does not support this hardware". Can't find anything o...

I am trying to set up a situation where after a call has been in que for 5 minutes I will check the Geotel to determine routing. What I have found is that as soon as I que the call to a skill on the Avaya my adjunct step does not work. If I skip over...

For the 'Personal Address Book' services feature in ip phone, there is one column call 'Nickname', when we want to key in the alphabet for searching, but it only allow us key in the number, do you know how to modify it?

The "Bills" report in CallManager CDR Analysis and Reporting is very nice because it provides all the information I look for. Is there a way to generate this report for inbound calls also? It would be nice if there was a report that would show CDR ...

I'm looking to see if I can find anywhere what specific toll-free numbers was used in a translation route. We're finding that when troubleshooting it is hard to narrow which toll-free number may be having trouble. I checked TerminationalCallDetail an...

Do you know of a document that covers the hardware specs of the 7835, 7837, 7847.I know the 7835 is a Compaq DL 380 G2. I am looking for a good chart that would give more detail as far as hardware specs are concerned.Thanks

I can search CDR's by date and pull records, but whenever I attemp to generate a report I get an error that says the date is out of range, "1-Jan-1970 to 30-Dec-2002" is the only available date range. Has anyone else seen this?ART 1.1.1 / CallMan 3....

Hii have two "dial peers" commands with exact same destination pattern andi have two provider and i need each one of them to be routed on a 2 different ports but the first match is taken and all calls are routed on a single E1.are there a way to sepe...

I have a customer that would like to upgrade both their CM and Unity.Currently CM 3.1.3a(SPf) (Pub and Sub) & Unity 3.1.4 (not integrated into their exchange enviroment).Destination versions are CM 3.2.2c(SPg) & Unity 3.1.5Intro Question: Should Uni...