Other Collaboration Subjects

Hi,Has anybody heard about the Arch attendant console, that Cisco is working on and is expected to realease soon. It is supposed to provide advanced features for the switchboard operators.I could not find any information on the web, maybe I am search...

In our Hospital we have a dozen or so dictation phones. these are 3rd party phones with various buttons used by doctors to access the dictation system. The phones connected to the VG248 are having issues where the DTMF tones are not working properly...

Hi,does anyone know how to make a CME extension auto answer? I have to still be able to call out from that extension, so it cannot be an intercom dn.Thanks,Dragi

Hiwanted to implement the following:analog_phone--router-----ipv6 backbone-----router---analog_phoneseems that the IOS 12.4(5) doesn't support this commandRouter(config-dial-peer)#session target ipv6:2000::1/64Incorrect format for Session TargetMust ...

Folks, Does anyone know from where can i get a BAT Template for BAT/TAPS. I do not see it on the sever.Thanks

We have a 2851 MGCP PRI gateway connected to CallManager 4.1.3. About once a day, outbound calls will stop routing and we have to do a "no mgcp" and "mgcp" to get the PRI back up. We have changed IOS to see if it is possible bug. I really don't wa...

I have some 7905 phones connected to Catalyst 2950T switches. I also have some 7960s and 7912s at the same sites.Gateways are 2801s and 2811s.I know 7905 phones work at 10 Mbps Half-duplex only.My problem is: either if I force the switch port connect...

I have configured a number of routers from the same config, all with a single e1 interface. I now want to apply the same config to a router that has two e1 interfaces. It should effectively work in the same way - just that I need 60 channels rather t...

When I attempt to update an auto registered phone I get the following message"...this phone already has a valid configuration"CCM 4.1.3 sr2CRS 3.5.4I used bat to add the phones to the call manager and used dummy mac addresses. The phones are the sam...

I have a client With one call manager for the Local site, Unity with Unified messaging. I need to set up SRST in case of CCM failure. How do I set up VM Pilot and VM ports in SRST?

I'm trying to get some advice.We want to route a fax ph# over our PTP into a right fax server. My question is, is this ok to do? Any concerns or things to watch out for? Here is the dial peer I’m going to use (keep in mind this is a fax dial-peer)dia...

Hi,I have a Cisco IP Communicator soft phone on my laptop which connects to VPN Client and works perfectly when Norton Internet Security 2005 (Version 8.3.0.5) is turned off. Can anyone really help me out by answering why when Norton Internet Securit...

Cisco 2800 Series with 10 POTS Lines connected to FXO Ports on the router. Intermittently calls are coming in but the line rings & rings & rings.POTS lines connected via Verizon to a main number hunt group. Verizon tested hunt group & lines no proble...

When I go to user group page I get the following error:An error occurred while the page was loadingError Number: -1 Description: Operations error