10-09-2001 03:51 PM - edited 03-12-2019 12:50 PM
I'm trying to configure a WS-X4604-GWY w/ VWIC-1MFT-T1 for an E&M wink trunk. The issue is that the "operation 4-wire" command is missing and the default is 2-wire. Is 4-wire note supported in 12.1(5)YF2? TAC had me go to this load to get the 8port FXS & DSPs working. Thanks.
10-09-2001 08:35 PM
You should not have to define operation 4-wire if you are using the t1 port. T1 only use 4 wires. You should just need the ds0-group under the controller to get the voice port and that should be fine.
Thank you,
10-10-2001 05:35 AM
Given how this equipment should work, I'd agree with you. When I do a show voice port 1/0:1 it states that the controller is operating as E&M type 1 two-wire. I have an existing Lucent PBX on this trunk set for ESF B8ZS 4-Wire E&M wink and it is running fine. I know the circuit is good. Any other thoughts on this? Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide