Other Network Architecture Subjects

we have a setup that needs to be running out to the internet 24/7. of course we don't have a budget for the techs to be there 24/7. 2 ISP's and 3 T1 lines. someone had suggested HSRP with 2 routers that we already have to make sure if our primary ISP...

I am trying to get to CCO via the Ciscoview >>Package Support Updater. I have entered both the cco login and proxy server but it does not work. I know and I am 100% sure that the values are corect. Using the same values in the Management Connection w...

All:OK to install Ethernet blades in nonconsecutive slots? Redundant Supervisor Engines and qty 3 48 port Etehrnet blades.I think using every other slot might make cable mgmt a lot easier.??tis/rgdsS

Hello everyone!Can anyone explain me: does 4912G switch support WS-G5483= (copper) GBICs? Or it supports only fiber GBICs?Thank you in advance.Victor.

Hi,We have a cat 6506. The first mod. is empty and the second is filled with a SUP I. The rest of the slots (3,4,5,6) are filled with ethernet modules. When we insert a second supervisor I in slot 1. The PWR MNGT led turns red. The two power supply's...

Hi,I'm trying to sync 1605R to a internet time source using the command:ntp server time.nist.govThe time failed to sync. Here're some of the capture.DEBUG NTP PACKETS03:54:11: NTP: xmit packet to 192.43.244.18:03:54:11: leap 3, mode 3, version 3, str...

I have a frame relay network with each remote node having two separate unequal paths back to the host node.The remote sites have 2620's with 1-768k and 1-56k frame relay link to the host 7206.The host has 2 separate 768k links, each with a link to th...

Hi: How can see in my routers what type of connection we are using (Frame Relay, End-to-End Leased line, Internet VPN, MPLS, and so on). What command i need to use.

Hi,I have a question that i think i already know but i just wanted to run it by some people.I have a 1760 with a VIC 2BRI-S/T interface installed.When i boot the router it just says "unknown card in slot 2"From the documentation it seems that these c...

I have been testing throughput on our 1711, and it seems locked at 10Mb/sec. This is for transfers from the WAN side on F0 to a client on the VLAN1 side on F1. I tried setting the "speed" setting for both interfaces to 100Mbps, but that did nothing. ...

Within the alerts and activites section I dont see any place to clear all the alerts from this. There is a acknowledge, but I dont see a way to remove the alert all together. Is there anyway to do this?Thanks..