Other Network Architecture Subjects

I have several 2950s installed in the last 10 months which I configured with IP address, gateway, DNS, time and date, location and disabling spanning tree. But some of the switches lose their time and date and DNS settings so they've reverted to the ...

Catalyst 6500, Sup 2, IOS 12.1(13)E. I can't seem to find a command that will provide the same details.Any help is greatly appreciated.Ariel

Can the 2900series and 3500 series switches support on the IPX protocol.?

Maybe some BGP guru out there can answer this question definitively:How does BGP treat the community attribute when used within confederations? Is the community attribute carried to the next AS outside the confederation, treating the conferation as a...

Hi all, I got a PIX 501 last week and wanna try configuring VPN client access from home to the office network.Can any one tell me how to and where to find the VPN Software and configure it.Thanks

I have a 6509 (running CatOS) with trunk connections to distribution switches using both SUP2/MSFC2 blades ports. We are plannig to change the Sw to SRM configuration and the document mention that you suppose do not have teh second blade (MSFC2 - non...

Need some help. We currently have 8 VLAN's coming in on one interface and they each run their own appletalk zone. I would like to prevent each zone from being seen in the other subnets. Do I need to stop it on the subinterface or in the main route...

I have 2 Layer 3 switch connected via infraredSw_A-----------InfraRed---------------Sw_BSw_A have 2 vlansSw_B have 2 vlansSw_B is where the internet connectivity isSw_B is therefore the default gateway of Sw_AQuestion.1. Am I violating any routing ru...

I just read some document saying that you need go into tranparent mode to enable extended vlan(1006-4096). My question is: 1.which server should go into tranparent mode, assuming that I have there 3550(1 server and 2 clients).2. After I changed it to...

I am studing FR traffic shaping. In command,it states that frame-relay cir x, this x means the physical port speed, like T1. I don't understand why we need this parameter in the traffic shapping, FR will never send traffic at this rate even without c...

Hi,When the primary urt server is rebooted, all hosts on dynamic ports lose their connections momentarily.Does anyone have any idea what is happening?Thanks in advance.

Hii have 3640 with FEand 3548XL SwitchRight now i have connceted one FE port with 3548XL Switch and running finedue to over load traffic on networki want to another port of FE from 3640so iam looking like thisi want to make 200MB Full duplexand load ...

I have problem with a cisco 2620 routerfrom log file:*Mar 1 17:25:04.483: %PQUICC-1-LINEFLAP: PQUICC(0/1), Excessive modem control changesThe 64kbit line provider have checket the line from a to b via the V.35 pulg. no problemI have changed the seri...

Hi,We are working her with ACS 3.0. It has always been working fine but all 221 users where in one group.Now we decided to create one group per department with the same group settings as the currect group of 221 users and move the users to there own ...

My W2k Dns is assigned a static address and the DHCP client has been stopped in the services control manager, but it is still leasing all of the address in its subnet from my IOS DHCP server. The address pool only has 10 available addresses. Here is ...