i have a normal 64 k isdn bri line at my office.as i have B channels availablei WOULD LIKE TO USE ONE B channel for dialin and other for dialout.is this possible and if yes could i have a sample config
HiI've seen the following LogMessages:%DUAL-5-NBRCHANGE: IP-EIGRP 2040: Neighbor 10.10.10.15 (Vlan60) is up: new adjacency%DUAL-5-NBRCHANGE: IP-EIGRP 2040: Neighbor 10.10.10.15 (Vlan60) is down: retry limit exceededWhy logging the active MSFC this me...
I have strange problem with Cisco Secure ACS 3.0I created group and for dialin users. I need to assign them IP addresses from a pool (created on NAS). Under Group IP assignment I selected "Assigned from AAA client pool". And under user "IP address as...
I need help to find out which version of IOS (feature set) I need toimplement a X25/TCP translation on a CISCO 2600 and CISCO 805routers.Please, where at Cisco WEB site I can found a list of IOS commandsand the software image / feature set that I nee...
Hello,, there is a backbone of catalyst 5000 swicth, there are more than 15 vlans conigured in that backbone. Recently, I was looking for all stp configurations for each vlan, what i found was that not all switchs in the backbone(all 5 switchs are co...
I have a customer whose network is flat at the present time. I have sold several access layer switches (3500XL series and 2950 series) to them over the past year. Recently i had them purchase a 4006 with a L3 blade (WS-X4232-L3) with the expectatio...
Hi,I've been experimenting with NBAR to eliminate traffic from Kazaa and Morpheus file sharing programs. I've got a 3640 running the latest IOS IP PLUS Image (c3640-ik9s-mz.122-12.bin). My problem is that when using the latest versions of both Morphe...
Hi I try to get an solution with a Cisco 2511 router running. My IOS I am using is 12.1 (Enterprise version). I got stocked with my IOS configuration.Scenario:I do have ONE 115 kbit leased line and SIX analog modems,each connected one ISP with differ...
I need to provide dial backup to over 700 stores for a polling service. It only polls 16 stores at a time so one PRI is enough. I have set it up with a dialer interface and multiple dialer maps for several stores and it works. Now I'm wondering wh...
I have a 6500 switch, and two 2924 switches. There are two ports setup as VLAN40 in my 6500. On those two 2924 switches, I didn't configure any VLAN's on them. I assigned two different IP addresses on each 2924 interface VLAN1, and hostnames on these...
When configuring two routers back to back with the serial interfaces, what is the maximum clock rate that can be used? I'm building a new lab out of old equipment and want to use and availble s0 interface to connect to the corp. DMZ for Internet acc...
