Hi,I'm trying to mirror all ports on a vlan to a single diagnostic port on a CE500 (using SPAN). However, I can't find out how to select more than a single source port..Anyone?
Hi,I'm trying to mirror all ports on a vlan to a single diagnostic port on a CE500 (using SPAN). However, I can't find out how to select more than a single source port..Anyone?
Hi all, can I config the token ring port on the router for ethernet? I want to use the 2612 for dhcp...so I need a second ethernet port.tx
Hi,we just bought Cisco CE500 switches of 10, since it doesn't support CLI, i was configuring the switches with the CNA, but struggled a bit, but couldn't find how to make the gigabit port as trunking? (i mean "switchport mode trunk" command which is...
My network consists in one 2950 switch with 2 vlan's, one to access my corporate network and the other to directly access de internet, with a 802.1q trunk i forward the traffic of both vlans to the internet with a cisco 1760 one encrypted and the sec...
Hello,Can anyone tell me if the queueing mechanisms on both these h/w platforms above are the same.I beleive that there are only two ingress queues PER SWITCH and four egress queue per port.If this is correct, why is there only two input queue per s...
Hello dear colleagues!I have the following problem.I use NAT. And all traffic going from the outside to a local IP-address (e.g. Internet) generates NetFlow packets missing info on the local IP-address. Instead of this they contain external IP-addres...
Hi, just wanted to know the upgrading proceedure on CatOS on Sup2 in 6509 is correct?copy tftp bootflash: Cat6509> (enable) copy tftp bootflash: IP address or name of remote host []? 10.10.10.2 Name of file to copy from []...
I there a way of disabling VTP from sending advertisements out certain trunk ports on a per port basis. IOS is 12.2 running on cisco WS-C6506-E.
I have been trying to get RSPAN working on my two 2950 switches.Earlier I had enabled SPAN on my switch (say Switch1) with Snort monitoring port fa0/24 and everything worked fine.Now, I have another 2950 switch (say Switch2) which I have connected vi...
I have LAN network, and about 500 clinets, can anyone tell me the TCP and UDP Ports which should be blocked through Access-list in our network, Becuase i would like to secure my network from external intrusion.Thank You
if I have a specific network going to one router and a default route via another router, if the router with the specific routes pointing to it goes off, will it use the default route ?
Can anyone give me a simple explanation why we would use a virtual template, are they like a dialler interface ?
Here our provider links all our sites via point to point crypto maps on a wes circuit, will all these point to point maps be on there own /30 masks, how are these set up with regards to addressing etc ?
hi all, can anyone answer this for me, If im using 192.168.1.253/30, can I still use the full 192.168.1.0/24 somewhere else ?
Hi guys,How can we disable the visrtual interfaces that are used for infrastructure devices comunication? On ciscoworks we receive many alarms of performance because of that virtual interfaces :( All the 1100 and 1200 APs are configured as root devic...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
02-20-2024 07:45 AM | ||
02-15-2024 09:08 AM | ||
02-14-2024 04:00 AM | ||
11-10-2023 09:28 AM | ||
11-09-2023 09:30 AM |