Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
271
Views
0
Helpful
2
Replies

Interface resets

earleyk
Level 1
Level 1

‎01-10-2002 05:57 AM - edited ‎03-01-2019 07:59 PM

I have a new location that I have just added to our wan. I'm getting an intermittent net connection and have found the serial port that the T-1 is attached has had over 11,000 interface resets and carrier transitions in the 10 days the link has been up.The CSU's are not showing any errors. I can't find any likely causes. Any ideas are appreciated.

Labels:
0 Helpful
2 Replies 2

svermill
Level 4
Level 4

‎01-10-2002 05:36 PM

Off hand, my first thought would be to check the timing config. Make sure that someone is clocking the circuit.

0 Helpful

ali-franks
Level 1
Level 1

‎01-11-2002 01:10 AM

Hi,

Scott suggested the timing, but I was wondering if one end of the link was on fibre and the other a 2Mb HDSL bearer?

0 Helpful
Customers Also Viewed These Support Documents