Other Security Subjects

I have a very simple problem. My Pix506e can ping everything on both sides of it, but my LAN side cannot get to anything on the WAN side of the PIX. I figured that my default route must be incorrect, but I followed the instructions correctly. Can ...

i just upgraded my 4210 to 4.0. I launched IDM and I can't find IEV 4.0. I click on Monitoring and nothing is there. I'm using IE 6.0Help please

I've got an ACL that's about 300 lines long. I want to remove the 4th item from the top. I also want to insert 2 entries below line number 7. How do I do this?

hello, at the moment, i have a crypto-map configured on my outside interface,where my vpns are defined with each sequence number...crypto map x ...crypto map x interface outsidenow i want to configure pix for vpn_clientso i create a dynamic-map crpyo...

did find in documentation these type of messageswhat is the meaning of these ?thanksJYP04/09/2003 15:07:10UTC E ERROR - cannot specify both ChokeThreshold and AlarmInterval for SIGID 690104/09/2003 15:07:10UTC E ERROR - cannot specify both ChokeThre...

I want to install IDS and CSPM from scratch . Anybody can give me the link which can help me to install both IDS and CSPM ? I have the book for CSIDS , which chapters should i read 1st . I know i should read the whole book but because of time i could...

Hi all,I have a pix 501/515. When a packet arrived into my pix, i must change its destination's address. If that possible with a nat/global command ? if my packet is [source=192.168.3.1|dest=200.0.1.1] i'll obtain [source=192.168.3.1|dest=10.0.1.1].T...

Can you pls help? I have been setting up PIX515 for our company, I just could't work out why traffic from lower security interface to higher security interface does't happen. I have 6 interfaces in my PIX515. I am trying to allow any traffic from tm...

I would like to set certain privileges to different users in the PIX but when there is a telnet session to the PIX. When I set the username level to anything over 1, the user gets full access. Is there a way to set the privilege level to allow cer...

Scenario: customer has eight sites, two of which are on an ethernet-type broadband connection (this is a service locally provided, with the router being fully transparent at the ISP side - you just plug an RJ45 in a socket and you are on the Net, wit...

Is it possible to disable the conn timeout value for a connection from a single IP address while allowing the value set in the timeout command for all other connections? I have a connection that needs to stay active even if there is no traffic for se...

I'm using multiple 1710's in my network. Remote sites use the AUX port to call back Head office 1710 modem if their connection goes down. The problem with this is only one connection is allowed. The rest of the remote sites will get a busy signal.I w...

By mistake I deleted the enrollment the identity certificate for my Cisco 3000 Concentrator. Now I can not install the certificate, which I got. Can somebody help me ?ThanksEva

Hey All,Trying to upgrade from a watchguard to pix 515e. The watchguard was allowing my class c public set of ip address to reside behind the firewall (without nat).Is there a way to accomplish this with the pix? If so, could you let me in on the sec...