Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can I carry out source and destination static NAT on a PIX515E

I have been asked to carry out NAT on a PIX515E. The requirement is to NAT both source and destination IP address. All destination addresses will be static 1 to 1 mappings whereas the source may be either static or a pool.

Is this possible and how do I configure this?

1 REPLY
New Member

Re: Can I carry out source and destination static NAT on a PIX51

Yes, You can do this starting from version 6.2. More details here http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094aad.shtml#topic12

116
Views
0
Helpful
1
Replies