Routing

Hi,I am facing an issue with one of my client that we are unable the access the internet once the firewall has been added in the network. Please see the configuration from the below and guide me to the resolution.Switch Configuration.interface Vlan50...

I have two Cisco 7600 and 4 Cisco SCE8000.I try connect two 7600 through etherchannel with sce.I read MGSCP design guide and configured src-ip load-balance on one 7600 and dst-ip on another 7600.I tested by test etherchannel load-balance command, IPs...

Hello All, Just a quick question for a cisco newbie. I'm having trouble using a 867VAE-K9 to connect to the NBN in Australia. Is it compatible? Appreciate any help. Regards,Leonard 

Hi Mates,Am not able to attach a QoS policy attached to an interface GigabitEthernet0/3. and getting the error message.Switch(config)#interface Gi0/3 Switch(config-if)#service-policy input QoS-SILVERQoS: Unsupported L4 protocol type matchQoS: Policy ...

I have a spare Cisco router 1941 that Ive setup to test with. I'm only using the GI 0/0 and 0/1 ports on it despite the router having a serial card installed which is not being used. I have made the gi 0/0 the internal interface and the gi 0/1 the ex...

Can you tell me if your Catalyst 3750 switch (*not* the –E or –X variants) support VRRP ipv4?  If so what version of firmware do I need?Thanks - Walt

Hi, I am due to teach some pupils the basics of MAC Addresses/IP Addresses and routing soon and I have a (hopefully) quick question which I am hoping someone here can help me with. When a frame is placed out onto a public network is has a destination...

Dear Sirs. We have an 3845 cisco router which constantly shows discard paquets at wan interface.there is not: saturation, CRC´s and any other anomalies at wan interface.The IOS of the router is:"flash:c3845-adventerprisek9-mz.151-3.T4.bin"and the con...

I can see constant ESP traffic coming from WAN and going to a VPN box connected on LAN which is causing high CPU the traffic flow is almost one way seems a replication and its around 80Mb. I check CEF and interface switching and not able to find any ...

Hi guys I am having lot of input queue drops on one of our remote router which has got an ipsec protected gre tunnel towards our main branch  Input queue: 0/75/168173/8 (size/max/drops/flushes); Total output drops: 0   Throttle count         37 Drops...