Routing

Hi Guys,Good day greetings...I not familier with this support community form i appolagize if there any mistake from my side in this post. The problem is i am not able access the shared folder in head office which is created before cisco implementatio...

Hi,I read sometime.. most of topics I know but sometime forget basics. May be good way yo use book again.I left some topics because they were too tuff and tired with them multicast etc ...but now ...want to do one good point ...anyone can help1- EIGR...

Hi all first time posting here forgive me if i posted in the wrong section   i have a problem with one of my ASR routers in a production environment, we are observing irregular cpu process percentages and response time on ssh terminal is quite slow. ...

Hi All,First of all sorry for my english.Sombody may already post this issue, but I hope I will get feedback and help from you. I really need Help.I have 3945 cisco router with the module (SM-ES3G-16-P) inside. The IOS of the module is c3560e-univers...

I got serious problem regarding route-map. the issue was that  the route-map doens't work correctly even applied.according to check, some route-map statement doens't contain 'prefix' which already removed. but, route-map have.when I remove that route...

Hello Experts,I have a pair of ASR 1002 running version IOS XE Version: 03.09.01.S  15.3(2)S1 that are showing a completely weird issue.Here is the Scenario:                          DATA CENTER In San Jose                             |              ...

any advice on firmware upgrade for a card mc7750 in 881w. this is vzw lte card. When executing the microcode receive the following error:The file flash:MC7750_VZW_03.05.10.06_00.cwe is too big!Firmware Upgrade Config file is needed to proceedwith the...

Hi All,I have 2 Cisco 2801 routers each populated with 1 HWIC-2SHDSL card in it. I would like communication to happen between 2 routers using the DSL line (RJ-11 cable).Unfortunately 2 Routers are not able to communicate over the DSL line as of now. ...

Hi all,I have the following topologyR1 -> RID 1.1.1.1R2 -> RID 2.2.2.2R1 has a static route towards 192.168.1.0/24R2 has a static route towards 192.168.1.0/24R1 and R2 belong to the same ospf area and same ospf process.R1 and R2 redistribuite the sta...

Hi All,We run a small datacentre network, about 150 servers between two data centres with a thrid coming online soon. We currenly have our /21 annouced by our upstream's BGP speakers and they route it to two of our Cisco 3825s which we use to subnet ...

Hi All,I want to police internet traffic and do per ip bandwidth limiting, what can be the best method to acheive this ? Right now i am doing it by divding my public pool into small sections and then imposing limit by configuring "Access-lists with d...