Routing

Hi,My setup is something like this.Cisco 1841 router--->asa 5510 sec bun---->Cisco 3560 L3 switch(running with some 15 different vlans),whcih is later on attached with some small 8 port switches to to increase the strength of the node/s. My problem i...

I have configured route-map on my two routers connected with a serial cable, my problem is when I do show route-map I dont see matches. below are my routers configs:Router Aaccess-list 110 permit ip host 192.1.1.2 anyroute-map policy_1 permit 10 matc...

Hello All,What can be the probable cause of this issue message following :"TCP/IP : Connection was closed by peer" ?Best regards,Stephane Tchoko.

Hi All,Please confirm whether 1841(C1841-ADVSECURITYK9-M), Version 12.4(3i)) support VPN connectivity without VPN module?

Hi All,Core router (6513) with OSPF area 0 (backbone/normal area). This is the onloy protocol on the router. Multiple vlans with diff /24 ipand all being advertised in ospf using 'network' statement. Do we still need 'redistribute connected' command ...

We leased p-t-p line from Verizon from USA to UK. We ship out to our London office 2800 with E1 interface and setup in our NJ office 2611 with T1 interface. Link doesn't coming up. It show me down/down on both sides. When Verizon set on the middle o...

HiI am not able to login to some deives in the network ,we are using ACS severerros is pasted belowUsername: *****Password: % Authentication failed User Access Verification Username: % User Access Verification Username: timeout expired!Can some one...

Hello friends , I connect two LANs together with two Cisco 2600 with PARADYNE 7975 M/SDSL.I can telnet each of them trough another router.But computers that each side can't ping another side.LAN1 IP address is : 172.20.0.0 255.255.0.0LAN2 IP address ...

Hello everyone,my company had a power outage over the weekend that apparently lasted longer than the UPS' could handle, and several of our switches lost power. No big deal, I back up the running configs every night at midnight, but now I'm unable to...

HiCan somebody pl clarify me whether PVDM cards will be available default in the router at the time of purchase or do we need to specify during the order.RegardsKarthik

Hi,I config the tunnel to route the PC-A's traffic to another site. The outbound traffic is ok, PC-A can access Internet. However, the inbound traffic does not work. what is the problem? is it the NAT mis-config? please refer attached diagramrdgs

HellomI seem to be having trouble advertising a prefix list to a BGP neighbor.Could anyone shed some light pls.Attached below captures the list of OSPF routes i have in the routing table. I have this redistributed onto BGP.O 10.40.0.32/30 [110/...

Dunno where to post this possible hardware problem. But here it goes.I bought 17 new routers with the following (all new).- Model: Cisco 2811 Router- DRAM: 256MB- FLASH: 128MB- 2 x FastEthernet- 1 Virtual Private Network (VPN) Module- ROM:12.4(13r)T-...

3750-24 How do I get rid of this error? Also I can't reach my NTP server. Is this related? I try to ping and says module is not installed?*Mar 6 14:51:16.391 PST: %IP_SNMP-3-SOCKET: can't open UDP socketing *Mar 6 14:51:16.391 PST: Unable to open ...

Hi, How we can synchronize PIM-DR & HSRP Active router.