Routing

wrr-queue bandwidth 10 20 70 1 wrr-queue min-reserve 1 5 wrr-queue min-reserve 2 6 wrr-queue min-reserve 3 7 wrr-queue min-reserve 4 8 wrr-queue cos-map 1 0 1 wrr-queue cos-map 2 2 4 wrr-queue cos-map 3 3 6 7 wrr-queue cos-map 4 5 priority-queue out ...

wrr-queue bandwidth 10 20 70 1 wrr-queue min-reserve 1 5 wrr-queue min-reserve 2 6 wrr-queue min-reserve 3 7 wrr-queue min-reserve 4 8 wrr-queue cos-map 1 0 1 wrr-queue cos-map 2 2 4 wrr-queue cos-map 3 3 6 7 wrr-queue cos-map 4 5 priority-queue out ...

Hi,I was able to do Multihoming with Two service provider with out Auto Failure.Can any one please help me on this .Please share the scenario and commands.Thanks,Akber.

Hi ! really appreciate if somebody has this solution/ever encountered this problem:-Wan conncations point to point================================I've one side cisco router with wic 2T serial card the others side is VWIC2-MFT-T1/EI ehich is second ge...

Hi,I'm trying to setup a small lab to understand OSPF. What are the minimum number of routers I need to get this working?I don't want to have to add static routes my routers and hope to make it dynamic so that routers are aware of each other and wha...

we have a 6 mg WAN pipe and a DSL connection would like to isolate the traffic to either the 6mg or the DSL by protocol or destination.is anyone moving WAN traffic like that?Thanks, Gary

Running a 7200 with IPX enabled over ATM link. All worked fine but all of a sudden I cannot see the IPX networks across the WAN link. The local IPX network is working fine and the IP networks appear to be fine. Any thoughts?

HI!I try to config a new sw 3560-24TS over the running express setup, but I dont access to my web browser 10.0.0.1 (default).

when I do an SLA static route tracking, after rebooting the router the tracked route is missing in the router. Is there any consideration to be done for static route tracking using IP SLA ? Please help

I can not enter boot# just came so boot> and need to recover or reset the password for enable cisco series 801 router

I'm in a scenario where I have two routers, configured with two loopbacks, connected together via two links. I'm in the process of transitioning from one loopback to the other and I was wondering if there are any caveats to having two sessions up...o...

Question:We have a Frame-relay network with hub-n-spoke type topologies at various sites. I would like to know how I should be configuring the 'bandwidth' statements on my serial and sub point-to-point interfaces. Should I put the typical T1 bandwi...

hi,i have applied the following line of code for blocking p2p in ASA but it blocked all of my traffic. please help me.http-map inbound_http content-length min 100 max 2000 action reset log content-type-verification match-req-rsp action reset log max-...

Cisco 3750G switches does not support Egress policing. Is there any workaround for this?RegardsSubbu