Routing

We're looking for the best technology solution to most quickly recover from a single T1 outage, in a dual T1 lease-line setup.Time sensistive application means we are looking for minimum recovery time from a failure.

it would apear (though no fault of our ADSL service provider Telus), that our 850 Cisco router drops out WAN link over our FastEthernet4 port, approimately once every 4 days. This has been happening consistantly over the past 3-4 months. Has anyone...

I was wondering whether I could use WIC-2A/S into my new 1841 router . Are they compatible . Thanks

Well, we have in subj mentioned hardware with line module X6724SFP+DFC3C, it works as our border - aggregates full views from 4 uplink providers and propagades it to mpls-core.There is 30 ebgp/ibgp peers & 6 ip-ip tunnels.Overall traffic-load is abou...

We have a critical server that originally could not be a routed connection to the DR server in our DR site. It had to be on the same subnet, so it was bridged to the DR site. The server is using the BVI interface as it's default gateway. We now need ...

Hi GuysPlease guide me in buying router for my branches, Is one router will be enough or I dont know what will be the design , please guide to achieve my following requirements :- On Branch Office I will be connecting through MPLS as primary link- IP...

hi.I have a quick question for and I was wondering if anyone could help.I want to creat an Internet Only vlan for our Guests, which would save the cost of 4 DSL lines. For example, our internal network is 172.17.0.0, and I want create VLAN 161 and a...

I am trying to setup 2 routers Lab.Routers: 2501 and 2524.Q. How do I connect these two routers by cables. I have one transcevier only. one rollover R45 cable. I have configure both the routers. But don't know how to connect these and make CN...

We have a 3725 router, two ISP's, one is wired and one is wireless. We also have an ASA5520 firewall in place inside the router. We would like to have failover and also traffic balancing. For example, inbound traffic to our company we want that tr...

Hi,Does any impact when man runs alot of Windows Vista where Ipv6 enable in a ipv4 network. Is there any problem for the network.

we currently have 2 asa's 5505 and a 5510 each connected to a isp which connect inside to a single 3640 we have the default route set to go out one isp and vpn traffic to go out the other. we have some route map polies in place for specific machines ...

Hello,I am trying to get NAT to work on a 7613 w/sup720 and am having some unexpected results.IOS Version 12.2(18)SXF7MSFC3 Sup720Here is the config:interface GigabitEthernet9/44 ip address X.X.100.1 255.255.255.0 ip nat outside spanning-tree portfas...

I have a 6509 with a 30Mb internet connection. During certain times of the day, this connection is maxed out. At these times I am seeing dropped connections from applications including Citrix connections. What are the possible reasons for these dropp...