Routing

Hi,Is there any way to access router's console using modem connected to AUX port?Thanks.

I have installed 2 unit of cisco 7609 at my site using SUP7203B. A few month ago, the router running under testing phase and all 4 LED are green (for active SUP). Right now, after power it down and power up again repeatedly, the "SYSTEM" status LED...

controller E1 x/y/z channel-group 0 timeslots 1 channel-group 1 timeslots 2 <repeat for all needed channels> interface serial x/y/z:0 ip address ... Kindly give me the complete sample configuration of about mention configuration commands.(G703/G704)

Hi All,I have a router at a remote site and want to configure a new router remotly. For that i want to connect a roll over cable from old router aux port to new router console port.How do i access the new router after telneting to the old router. Is ...

what will be the effect of ip nat if you implemented in one interface< ip nat inside for f0/0, ip nat outside in f0/0.100>

Is there away to shutdown an interface if it recevies a prediscibed amount of errors per secound?

greetings!!!i would like to raise this question with regards to ip nat translation, let say i have a 2000 users using a private ip's and a public ip of /24 question is how many ip from public to translate the 2000 users using a private ip.

1.In Router & Switch how can i find out SNMP Community string's version & it's permission(Read/Write)?

how to configure G703 ethernet interface ,in background of this many different locations are connected with one G703 interface, Kindly advice.

Hello everyone,Try to setup two VLNANs, one 192.168.2.0/24 goes out for internet service, and 10.76.10/24 goes fro crypto map via site to site tunnel. Please help to verify the configuration:! !crypto isakmp policy 10 encr 3des authentication pre-sha...

what "return route" mean? my colleague is asking me what is the return route between points. is this the same as "sh ip route"? thanks....

Hi,Hi guys i am facing problem in one of my router , i was trying to get the sh tech support for that router, i am getting following sh tech support format , i have seen first time can any body tell me wht is the problem and when i am getting such ty...