Routing

I want to evaluate Cisco WAAS. Questions:1) On my two remote sites which will be used for testing, routers are 2600 and 3660. It is very hard for me to replace routers there on a timely manner.If I grab a 2800 for the testing and add WAAS module on i...

I have many routers set up as VPN's. Sometimes I have to access the routers using their public IP via telnet, is this sent in clear text? If so do you recommend ssh? If so how can I set this up on a Cisco 877 or 1841?Thanks

Hi guys, How many VWIC-2MFT-E1 can I install and configurate in a router 3825? Thank!!

I'm running into a problem here I'm trying to take off compression on a serial interface. I do the "no" form of the command on the remote router but then when I do the same on the local router I can no longer log back into the remoter router. I've d...

We are using 871's for remote user access and so far I have not found any issues with the built in firewall. However today one user has asked for assistance getting a Slingbox to work. This brings up my question concerning UPnP. Does the 871 suppor...

Dear sir,Can i segrigate the banwidth with single leased line from the HO to multiple BO.Using 3560 switch or any possibility on 1841 router.Regardssrinivas

Hi Folks,I have a 2811 router in which I have configured one of interface for Metro Ethernet connectivity to Service Provider.The problem is that I am not able to access in respect to Ping, Trace or Telnet from outside (on Fast Ethernet where Metro E...

Hai all,Can any one help me in understanding LDP (How label swapping is happening in MPLS ) /Tag switching ... and how vrf is created ... How customer data is traversed via MPLS Backbone ..(VRF information is attached with the label ... pls help me r...

All, I have a 2801 and a 3800 routing WAN Traffic. At both ends, I have a SAN that we do replication with. My Question, I can I throttle the bandwidth or control how much bandwidth that the replication uses?

Where can I get a Trial version of ACS 3.2 Server for Windows for download?

I have a current need to perform two way redistribution of EIGRP to BGP. So the network is setup like this:I have redundant paths between two locations. 1 of the paths is a 100MG optical ethernet. The other is a 45MG DS3 that goes to an MPLS at lo...

How should elect the DR/BDR in the attached network. All connected interfaces are on different /29 network.1. R1-Sw1 = x.x.x.0/292. R2-Sw2 = x.x.x.16/293. SW1-SW2 = x.x.x.24/29all are configured as AREA0 and wanted R1 as DR and R2 as BDR.It involves ...

We are setting up our first site to do VOIP over our MPLS network. We have a CME in our remote site and CCM in our head site. Our service provider has us set up with EF Que for the voice priority EF QUE. On the remote side we have a 2811 which I h...

Apparently the Cisco 877 and 837 routers should have the IP nbar option an an interface. Mine don't. The readme for Netflow says:Platforms & Cisco IOS Versions that currently support CISCO-NBAR-PROTOCOL-DISCOVERY-MIB areCisco 1700 Series Router sin...