Routing

Hi All,Can someone tell me the difference between doing the following:ip route 10.0.0.0 255.255.255.0 FastEthernet1/0andip route 10.0.0.0 255.255.255.0 10.0.0.1I did the first one on my router to begin with and it did not work, but the second did. W...

Hello,I am in the process of ordering a 3800 series router for Japan. I've never ordered internet connection out-of-US before. what are some of the concerns I should be addressing with Japan's ISP?I also would like to know what WIC is appropriate f...

Hi,I have a problem with a site to site vpn connection between a dg834g and a cisco 1803. Everything works for about 3min then stops and comes back for 3ish mins. The only thing i can see is this error message :-DPD: No response from peer - declaring...

Hello,I would like to know how to disable http so when I go to http://192.168.1.1, I dont want to userid & password prompt.

Hi,I have a question regarding GRE tunnel interface over Internet DSLs, encrypted using IPSec. We use below config:interface Tunnel1 bandwidth 1000 ip address <ip> <mask> no ip redirects ip mtu 1272 ip nhrp authentication <auth_profile> ip nhrp map <...

Hi, if you are looking to change the MTU size of a link, do you have to do this at the same time for all connections along a path between a source and destination? In this case the source and destination are within the same AS.Thanks

Maybe someone has some experience with SBC (AT&T) DSL? I cannot seem to get the ATM Interface to come up. I called SBC and checked through all of my settings, Changed the cable, etc. I know that I am missing something. Any thoughts or help would be g...

Following is my setupRA---- Router ARB----- Router BRC----- Router CRC-512kbpslink--RA--2Mbps ink-RB-128Kbps-RCRA is connected to RC with 512 kbps link and RA is also connected to RB with 2 Mbps link.Again RB is connected to RC with 128 link.we are r...

hii would like to know what the diffrence between the ip tcp adjust-mss command to ip mtu command.when i need to config the first one command and when i need to config the second.thanks

We?ve got a new point-to-point 2,048Kb circuit which I?m trying to use for the first time. Normally I?d have the line terminated as X.21 at each end, and connect with no problems. However this circuit is terminated as G.703 at one end and X.21 at t...

Hi....I am new to QoS and need help on configuring the same for 7206 VXR.My test topology is as follows :The Emulated router is configured using IXIA traffic generator using the GUI with one port sending the marked and classified traffic and the othe...

I have an EIGRP WAN with 2 routers at each location. Each router at remote sites has a T1 connection to a MPLS WAN provider (one to AT&T and one to Sprint). And at HQ office and DR location I have one router with a 10M connection to AT&T and one rout...