04-05-2009 11:00 PM - edited 03-04-2019 04:15 AM
Hi Everybody.
I am trying to configure Cisco 1841 Router Ethernet ports fa 0/0 & fa 0/1 into a single bundle similar to Teaming which is done in Servers.
So that we can configure one IP address for both the ethernet ports and connect two cables for redundancy.
Is it possible to achieve this design? Kindly help
R.B.Kumar
Solved! Go to Solution.
04-05-2009 11:28 PM
Hello R. B. Kumar,
you can do this with IRB but only one physical link will be active at any given time.
bridge 1 protocol ieee
bridge 1 route ip
int f0/0
no ip addr
bridge-group 1
int f0/1
no ip addr
bridge-group 1
int BVI1
desc logical L3 interface for bridge-g 1
ip address 10.10.10.1 255.255.255.0
no sh
STP will block one of the two links
Redundancy can be achieved and you can connect the two cables to two different lan switches
Hope to help
Giuseppe
04-05-2009 11:28 PM
Hello R. B. Kumar,
you can do this with IRB but only one physical link will be active at any given time.
bridge 1 protocol ieee
bridge 1 route ip
int f0/0
no ip addr
bridge-group 1
int f0/1
no ip addr
bridge-group 1
int BVI1
desc logical L3 interface for bridge-g 1
ip address 10.10.10.1 255.255.255.0
no sh
STP will block one of the two links
Redundancy can be achieved and you can connect the two cables to two different lan switches
Hope to help
Giuseppe
04-05-2009 11:40 PM
Hi Giuseppe,
Very useful input.My sincere thanks
R.B.Kumar
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide