Help with 3800 Series to have pppoe

[nekaratal]

Hello all, i would like to ask whatsthe confiuration for cisco 3845  router, my set up is DSL Modem> Cisco3845>PC, my internet is  Static but it need to dial a username and password, but i cant seem to  make it work, been doin it for almost 2 weeks now but i still dont get  internet access hope to hear from you soon, im new at configurin this  routers and i dont know if im doing the right codes for it, sorry to  bother you all, have a reat day

[nekaratal]

Cisco 3845 (revision 1.0) with 225280K/36864K bytes of memory.
Processor board ID FHK1209F19G
2 Gigabit Ethernet interfaces
1 terminal line
1 Channelized E1/PRI port
1 cisco service engine(s)
DRAM configuration is 64 bits wide with parity enabled.
479K bytes of NVRAM.
62720K bytes of ATA System CompactFlash (Read/Write)

Configuration register is 0x2142

[KARUPPUCHAMY MALAIYANDI · Accepted solution]

Hi,

You need to change the config register in to 0x2102.the configuration register shows 0x2142. The             router bypasses the startup configuration stored in NVRAM during its boot             sequence. This feature is normally used during a password recovery             procedure.

router(config)#config-register 0x2102

then write the confiig. reload you router.

Regards

Karuppu

[nekaratal]

its ok now thanks alot have a great day sir many thanks agan